Which of these are not referenced in an assembly? assemblies, sketches, part studios, surfaces, or plants

This statement accurately describes how headlines should be placed in business documents.

1. which of the following statements are true about routers and routing on the internet. choose two answers. a. protocols ensure that a single path between two computers is established before sending packets over it. b. routers are hierarchical and the "root" router is responsible for communicating to sub-routers the best paths for them to route internet traffic. c. a packet traveling between two computers on the internet may be rerouted many times along the way or even lost or "dropped". d. routers act independently and route packets as they see fit.

Write a program that displays the following menu: geometry calculator 1. calculate the area of a circle 2. calculate the area of a rectangle 3. calculate the area of a triangle 4. quit enter your choice (1-4): if the user enters 1, the program should ask for the radius of the circle and then display its area. use the following formula: area = ď€(the square of r) use 3.14159 for ď€ and the radius of the circle for r. if the user enters 2, the program should ask for the length and width of the rectangle and then display the rectangle’s area. use the following formula: area = length * width if the user enters 3, the program should ask for the length of the triangle’s base and its height, and then display its area. use the following formula: area = base * height * .5 if the user enters 4, the program should end. input validation: display an error message if the user enters a number outside the range of 1 through 4 when selecting an item from the menu. do not accept negative values for the circle’s radius, the rectangle’s length or width, or the triangle’s base or height. note: if the user enters an improper menu choice (1-4), the program prints "the valid choices are 1 through 4. run the program again and select one of those." if the user enters a negative radius, the program prints "the radius can not be less than zero." if the user enters a negative value for height or base, the program prints "only enter positive values for base and height."