The microprogram counter (MPC) contains the address of the next microcode statement for the Mic1 emulator to execute. The MPC value is either the next sequential microcode instruction in the control store (PROM), or a microcode instruction in the control store pointed to by the ADDR bits in the current executing microinstruction. What part of the current executing microcode instruction determines the value placed in the MPC

The most common battery cable terminal is a that provides a large surface contact area with the ability to tighten the terminal onto the battery post using a nut and bolt.

Given a link with a maximum transmission rate of 32.8 mbps. only two computers, x and y, wish to transmit starting at time t = 0 seconds. computer x sends filex (4 mib) and computer y sends filey (244 kib), both starting at time t = 0. statistical multiplexing is used, with details as follows packet payload size = 1000 bytes packet header size = 24 bytes (overhead) ignore processing and queueing delays assume partial packets (packets consisting of less than 1000 bytes of data) are padded so that they are the same size as full packets. assume continuous alternating-packet transmission. computer x gets the transmission medium first. at what time (t = ? ) would filey finish transmitting? give answer in milliseconds, without units, and round to one decimal places (e.g. for an answer of 0.013777 seconds you would enter "13.8" without the quotes)

It is not necessary to develop strategies to separate good information and bad information on the internet. true or false