Write a pseudocode to prompt a user to enter 3 grades in the range of 0-100. Then it computes the average of these three grade along with grade letter associated with the computed average according to the following table: The pseudocode outputs the average along with the grade letter with an appropriate message.
C++

In this lab, you complete a python program that calculates an employee's annual bonus. input is an employee's first name, last name, salary, and numeric performance rating. if the rating is 1, 2, or 3, the bonus rate used is .25, .15, or .1 respectively. if the rating is 4 or higher, the rate is 0. the employee bonus is calculated by multiplying the bonus rate by the annual salary.

Write a program that displays the following menu: geometry calculator 1. calculate the area of a circle 2. calculate the area of a rectangle 3. calculate the area of a triangle 4. quit enter your choice (1-4): if the user enters 1, the program should ask for the radius of the circle and then display its area. use the following formula: area = ď€(the square of r) use 3.14159 for ď€ and the radius of the circle for r. if the user enters 2, the program should ask for the length and width of the rectangle and then display the rectangle’s area. use the following formula: area = length * width if the user enters 3, the program should ask for the length of the triangle’s base and its height, and then display its area. use the following formula: area = base * height * .5 if the user enters 4, the program should end. input validation: display an error message if the user enters a number outside the range of 1 through 4 when selecting an item from the menu. do not accept negative values for the circle’s radius, the rectangle’s length or width, or the triangle’s base or height. note: if the user enters an improper menu choice (1-4), the program prints "the valid choices are 1 through 4. run the program again and select one of those." if the user enters a negative radius, the program prints "the radius can not be less than zero." if the user enters a negative value for height or base, the program prints "only enter positive values for base and height."

When creating a field in a table, you must set the to determine what type of data the field can store. field property data type field type data property