Engineering, 30.12.2019 23:31 rafrod75

Astandard x-band rectangular waveguide with dimensions a = 0.9 in and b = 0.4 in is filled with lossless polystyrene (er = 2.56). for the lowest-order mode of the waveguide, determine at 10 ghz the following values:

(a) cutoff frequency

(b) guide wavelength

(c) guided intrinsic impedance

(d) guided phase velocity

assume the waveguide of part 1 is to be interfaced with a hollow waveguide of the same dimensions.
to avoid reflections, an additional x-band waveguide (of the same dimensions) a quarter-wavelength long section is inserted between the two.
assume dominant mode propagation and that the operating frequency is 10 ghz.

(a) determine the guided intrinsic impedance of the quarter-wavelength section of waveguide.

(b) determine the dielectric constant of the lossless medium that must be used to fill the quarter-wavelength section waveguide.

(c) determine the length of the quarter-wavelength section waveguide.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 19:10

10 kg of co2 is initially contained at 400 kpa and 300 k. the gas constant for carbon dioxide is 189 j/lkg k) and has a specific heat ratio, k, of 1.289. isentropic expansion then occurs until the pressure is 200 kpa. a) determine the initial volume of co2 in m. b) determine the final temperature in k. c) determine the work done by the system during the expansion kl.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

With increases in magnification, which of the following occur? a. the field of view decreases. b. the ambient illumination decreases. c. the larger parts can be measured. d. the eyepiece must be raised.

Answers: 1

Answer

Engineering, 04.07.2019 19:10

Starting wih an energy balance on a rectangular volume element, derive the one- dimensional transient heat conduction equation for a plane wall with constant thermal conductivity and no heat generation.

Answers: 1

Answer

Engineering, 04.07.2019 19:20

Apiping systems consists of 6 m of 6-std type k and 12 m of 4-std type k, both drawn copper tubing. the system conveys ethylene glycol at a rate of 0.013 m3/s. the pressure drop across the system is to be calculated. there are two 90° elbows in the 6-in pipe, a reduction from the 6-in pipe to the 4-in pipe and four 90° elbows in the 4-in pipe. all fittings are soldered (same as flanged) and regular. the inlet and outlet of the system are at the same height.

Answers: 1

Answer

You know the right answer?

Astandard x-band rectangular waveguide with dimensions a = 0.9 in and b = 0.4 in is filled with loss...

Questions