subject
Engineering, 12.03.2020 22:29 nnance4784

In a Rankine cycle, superheated steam that enters the turbine at 1273.15 K and 1.8 MPa is then expanded to a vapor at 0.1 MPa. What is the shaft work generated per kilogram of steam if the efficiency of the turbine is 0.56

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 12:10
On a average work day more than work place firs are reorted
Answers: 1
question
Engineering, 04.07.2019 18:10
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 ยฐf at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
question
Engineering, 04.07.2019 18:10
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
question
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
You know the right answer?
In a Rankine cycle, superheated steam that enters the turbine at 1273.15 K and 1.8 MPa is then expan...
Questions
question
SAT, 08.12.2020 18:00
question
Computers and Technology, 08.12.2020 18:00
question
Chemistry, 08.12.2020 18:00
question
Mathematics, 08.12.2020 18:00
Questions on the website: 13722360