Engineering, 05.04.2020 17:08 xxkeyxx51
: Built-in beam of length 6 m was loaded with two concentrated loads 20kN at point (B) 2m from left support (A) and 40kN at point (C) 2m from right support (D), and triangular load start from point (B) 0kN/m to point (D) 24kN/m.
If E=200GN/m2
I= 0.000001m4
Determine:
1. The reactions and fixing moments
2. Slope and deflection at point (C)
Answers: 2
Engineering, 03.07.2019 15:10
If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.
Answers: 1
Engineering, 04.07.2019 18:10
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
Engineering, 04.07.2019 18:20
For a gate width of 2 m into the paper, determine the force required to hold the gate abc at its location.
Answers: 1
: Built-in beam of length 6 m was loaded with two concentrated loads 20kN at point (B) 2m from left...
Mathematics, 30.06.2019 07:30
Social Studies, 30.06.2019 07:30
History, 30.06.2019 07:30
Social Studies, 30.06.2019 07:30
Mathematics, 30.06.2019 07:30
English, 30.06.2019 07:30
History, 30.06.2019 07:30
History, 30.06.2019 07:30
History, 30.06.2019 07:30