Engineering, 14.04.2020 18:25 ashleyuchiha123
An inspector must inspect a production batch of 8,000 parts using a gaging method. If the actual fraction defect rate in the batch is 0.02, and the inspector’s accuracy is given by p1 =0.98 and p2 = 0.78, Determine:
a. the number of defects the inspector can be expected to report.
b. the expected number of Type I and Type II errors the inspector will make.
c. What is the expected fraction defect rate that the inspector will report at the end of the inspection task?
Answers: 2
Engineering, 03.07.2019 14:10
If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.
Answers: 3
Engineering, 04.07.2019 18:20
Acertain flow of air (at stp) has a velocity distribution given by v i (in ft/s). if this flow is going through a 4 ft square area in the yz-plane (centered at the origin), what is the mass flow rate (in lbm/s)?
Answers: 2
Engineering, 04.07.2019 18:20
Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.
Answers: 1
Engineering, 04.07.2019 18:20
Modern high speed trains do not have perpendicular expansion gaps where rails are joined end-to-end any more they are mostly welded together but what might happen if there was a spell of particularly hot weather that causes inspection of the tracks?
Answers: 1
An inspector must inspect a production batch of 8,000 parts using a gaging method. If the actual fra...
History, 11.07.2019 04:40
Biology, 11.07.2019 04:40
Mathematics, 11.07.2019 04:40
Chemistry, 11.07.2019 04:40
Physics, 11.07.2019 04:40
Mathematics, 11.07.2019 04:40
Mathematics, 11.07.2019 04:40
Chemistry, 11.07.2019 04:40
Mathematics, 11.07.2019 04:40
History, 11.07.2019 04:40
Mathematics, 11.07.2019 04:40
Mathematics, 11.07.2019 04:40