Engineering, 20.11.2020 01:00 taehyungg
1. A simple steel pipe being used as a bracket to support equipment through cables
attached as shown in Figure 1.
А
Pipe
120 cm
B
F1 = 36 kN
36 kN = F2
90 cm
30°
30°
С
12 kN = F3
Figure 1: Steel pipe
a). Select the smallest diameter steel pipe using the nearest value area calculated that
will limit the stress to no more than 124 MPa (Refer Appendix 1).
(15 marks)
b). Determine the total downward deflection of point C at the bottom of the pipe as the
loads are applied using the pipe selected in Question 1(a) (use the value area selected).
(10 marks)
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
Engineering, 04.07.2019 18:10
The drive force for diffusion is 7 fick's first law can be used to solve the non-steady state diffusion. a)-true b)-false
Answers: 1
Engineering, 04.07.2019 18:10
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
Engineering, 04.07.2019 18:10
The higher the astm grain size number, the finer the gran is. a)-true b)-false
Answers: 2
You know the right answer?
1. A simple steel pipe being used as a bracket to support equipment through cables
attached as show...
Questions
Computers and Technology, 13.08.2019 05:30
Computers and Technology, 13.08.2019 05:30
History, 13.08.2019 05:30
