subject
Engineering, 02.03.2021 19:20 autumnplunkett09

While recharging a refrigerant system, the charging stops before the required amount of refrigerant has been inserted. What should a technician do at this time? A) start the engine and charge through the high side
B) open the low side valve to allow charging through both sides
c) start the engine and charge through the low side
d) reevacuate and recharge the system again

ansver
Answers: 1

Another question on Engineering

question
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
question
Engineering, 04.07.2019 16:10
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
question
Engineering, 04.07.2019 19:10
With increases in magnification, which of the following occur? a. the field of view decreases. b. the ambient illumination decreases. c. the larger parts can be measured. d. the eyepiece must be raised.
Answers: 1
question
Engineering, 04.07.2019 19:20
Apreheater involves the use of condensing steam at 100°c on the inside of a bank of tubes to heat air that enters at 1 atm and 25°c. the air moves at 5 m/s in cross flow over the tubes. each tube is 1 m long and has an outside diameter of 10 mm. what is the minimum value of nl needed to achieve an outlet temperature of t 75 c? what is the corresponding pressure drop across the tube bank?
Answers: 3
You know the right answer?
While recharging a refrigerant system, the charging stops before the required amount of refrigerant...
Questions
question
Mathematics, 30.01.2020 10:55
question
Mathematics, 30.01.2020 10:55
Questions on the website: 13722359