Engineering, 29.03.2021 23:50 BigGirlsTheBest
Work out the Absolute X and Y Coordinates for the various positions to machine the contour X0 Y0 is at the lower left corner of the part Use a 0.5” diameter End Mill Tool #4 Start at X0 Y-.375 and machine the contour in a clockwise direction – climb milling Use X-.375 Y.125 as point 11
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 03:10
What precautions should you take to prevent injuries when dealing with heavy loads?
Answers: 1
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10
An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature
Answers: 2
You know the right answer?
Work out the Absolute X and Y Coordinates for the various positions to machine the contour X0 Y0 is...
Questions
Mathematics, 13.07.2021 19:50
Geography, 13.07.2021 19:50
Law, 13.07.2021 19:50
Mathematics, 13.07.2021 19:50
Chemistry, 13.07.2021 19:50
English, 13.07.2021 19:50
Mathematics, 13.07.2021 19:50
English, 13.07.2021 19:50
Mathematics, 13.07.2021 19:50
Mathematics, 13.07.2021 19:50
Mathematics, 13.07.2021 19:50
