Engineering, 04.04.2021 14:00 wbrandi118
You are required to design a circuit which has input decimal number in binary form as A, B, C, D with A as MSB and D as LSB, and generate Excess-3 output in binary form as W, X, Y, Z with W as MSB and Z as LSB. Also implement your design to verify your results. Conditions are as.
• When ever result exceed than number of output bits or in negative value or invalid, it does not matter for you.
• You should make up truth table accordingly.
• Draw its logic diagram.
• Implement simplified logic diagram which shows excess 3 output in Multisim.
Answers: 3
Another question on Engineering
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
Engineering, 04.07.2019 18:20
Inspection for bearing condition will include: (clo4) a)-color b)-smell c)-size d)-none of the above
Answers: 1
Engineering, 04.07.2019 18:20
Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent
Answers: 2
Engineering, 04.07.2019 18:20
An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid
Answers: 3
You know the right answer?
You are required to design a circuit which has input decimal number in binary form as A, B, C, D wit...
Questions
History, 10.03.2020 06:52
Chemistry, 10.03.2020 06:53
