Calculate the required diameter in inches.* 1 point
p = 125 in
F=300 lb.
d=2
A device on an assembly line uses a pneumatic cylinder that produces 125 lb/in.?
of gauge pressure to push products off the line. What is the required diameter of
the pneumatic cylinder that is needed to move products that weigh 300 lb?
0.13
0.87
1.75
0.36

Plot schematically the tensile stress versus strain curves for a typical thermoplastic material at a temperature below its glass transition temperature (tg and at a temperature above its tg, respectively. do the same for a typical thermosetting material. list in a table any differences or similarities between the two materials at t> tg and t < tg, respectively, and relate them to the structures of the two types of polymers