Engineering, 21.10.2021 18:20 paulusl19

1. A flywheel is suspended by resting the inside of the rim on a horizontal knife edge so that the wheel can swing in a vertical plane. The flywheel has a mass of 350Kg. The knife edge is parallel to and making 350mm from the axis of the wheel. The time for making one small oscillation is 1.77 seconds. Assuming that the centre of mass is in the axis of the wheel, determine: (I).The radius of gyration of the wheel about the axis.
(II). The torque to increase the speed of the flywheel at uniform rate from 240 rev/min to 250 rev/min in 0.75seconds when the flywheel is revolving about its axis.
2. A solid metal cylinder 450mm diameter is suspended with its axis vertical by means of a wire coaxial with the cylinder and rigidly attached to it. The stiffness of the wire is 22Nm per radian of twist. Find the necessary mass of the cylinder so that when it is given a small angular displacement about its axis, it will make 40 vibrations per minute.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

If a particle moves along a path such that r : (3 sin t) m and ? : 2t rad, where t is in seconds. what is the particle's acceleration in m/s in 4 seconds? a)- 16.43 b)- 16.29 c)- 15.21 d)- 13.79

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Machinery that is a key part of the process and without which the plant or process cannot function is classifed as: (clo4) a)-critical machinery b)-essential machinery c)-general purpose machinery d)-none of the specified options.

Answers: 1

Answer

Engineering, 04.07.2019 19:20

Aseries piping system conveys methyl alcohol. the system consists of 70 m of 1- nominal pipe follow by 50 m of 2-nominal pipe, both schedule 40 commercial steel. the 1-nominal pipe contains 3 90° elbows (regular) anda fully open gate valve, all threaded. the pressure drop through the system is 150 kpa. determine the volume flow rate through the system that is horizontally laid.

Answers: 1

Answer

Engineering, 06.07.2019 02:30

1in2 processor chip can be modelled as an isothermal plane wall of silicon, isothermal on both sides. the power input to the bottom of the plane wall, or the processing power of the chip, often called the thermal design power (tdp), is 100w. assume the periphery is adiabatic. the silicon is 400 microns thick. the temperature at the junction, or in this case on the bottom of the isothermal plane wall, is 85°c. what is the top surface temperature, assuming that the only mode of heat transfer is conduction

Answers: 1

Answer

You know the right answer?

1. A flywheel is suspended by resting the inside of the rim on a horizontal knife edge so that the w...

Questions