subject
Engineering, 14.12.2021 05:40 maxout67

A charged capacitor is connected to a 100-kΩ resistor. After 1 second the voltage across the capacitor becomes one-half of its original value. Find the

capacitance of the capacitor in the unit of μF.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 19:10
What is the chief metrological difference between measuring with a microscope and with an electronic comparator? a. the microscope is limited to small workpieces.a. the microscope is limited to small workpieces. c. the comparator can only examine one point on the workpiece. d. the microscope carries its own standard.
Answers: 1
question
Engineering, 04.07.2019 19:20
Acircular pipe of 30mm outside diameter is placed in an airstream at 30 c and latm pressure. the air moves in cross flow over the pipe at 20 m/s, while the outer surface of the pipe is maintained at 110 c. what is the drag force exerted on the pipe per unit length? what is the rate of heat transfer from the pipe per unit length?
Answers: 1
question
Engineering, 05.07.2019 23:20
Which one of the following faults cause the coffee in a brewer to keep boiling after the brewing cycle is finished? a. an open circuit in the heating element b. a short circuit at the terminals c. welded contacts on the thermostat d. a leak around the gasket
Answers: 3
question
Engineering, 06.07.2019 05:10
Draw each component in sequence for a steam (rankine cycle) power plant. draw the system boundary needed to analyze this cycle as a closed system. note: this should just be one figure below! else
Answers: 2
You know the right answer?
A charged capacitor is connected to a 100-kΩ resistor. After 1 second the voltage across the capac...
Questions
question
Mathematics, 16.01.2020 20:31
Questions on the website: 13722360