subject
Physics, 27.06.2019 20:40 Yungnaudie

Charges +3.0 μc and -6.0 μc are placed 5 cm from each other. find where the electric field equals 0 and where the electric potential is zero.

ansver
Answers: 1

Another question on Physics

question
Physics, 21.06.2019 17:50
Which of the following represents an upside-down image?
Answers: 2
question
Physics, 21.06.2019 18:20
Which is not a step in the rock cycle?
Answers: 1
question
Physics, 21.06.2019 22:00
In a wind tunnel the speed changes as the cross sectional area of the tunnel changes. if the speed in a 6' x 6' square test section is 100 mph, what was the speed upstream of the test section where the tunnel measured 20' x 20'? use conservation of mass and assume incompressible flow. conservation of mass requires that as the flow moves through a path or a duct the product of the density, velocity and cross sectional area must remain constant; i.e., that ova-constant. a model is being tested in a wind tunnel at a speed of 100 mph if the flow in the test section is at sea level standard conditions, what is the pressure at the model's stagnation point? (a) the tunnel speed is being measured by a pitot-static tube connected to a u- tube manometer. what is the reading on that manometer in inches of water? (b) at one point on the model a pressure of 2058 psf is measured. what is the local airspeed at that point?
Answers: 2
question
Physics, 22.06.2019 03:10
Athin plate moves between two parallel, horizontal, stationary flat surfaces at a constant velocity of v = 7.5 m/s. the two stationary surfaces are spaced 4 cm apart, and the medium between them is filled with oil whose viscosity is 0.9 n·s/m2. the part of the plate immersed in oil at any given time is 2 m long and 0.5 m wide. if the plate moves through the mid-plane between the surfaces, determine the force required to maintain this motion. what would your response be if the plate was 1 cm from the bottom surface (h2) and 3 cm from the top surface (h1)? if the plate moves through the mid-plane between the surfaces, the force required to maintain the motion will be n. if the plate was 1 cm from the bottom surface (h2) and 3 cm from the top (h1) surface, the force required to maintain the motion would be n.
Answers: 2
You know the right answer?
Charges +3.0 μc and -6.0 μc are placed 5 cm from each other. find where the electric field equals 0...
Questions
question
World Languages, 25.08.2019 17:50
question
Mathematics, 25.08.2019 17:50
Questions on the website: 13722360