PLS HELP FAST WILL GIVE BRANILEST

The diagram below shows four locations on Earth with respect to the moon and sun at a given time. Earth is shown as a circle with a smaller circle labeled Moon to the right of it and a larger semicircle labeled Sun to the right of that. Points W and Y are marked at the top and bottom ends of the circle representing Earth. Points X and Z are marked at the left and right sides of the circle representing Earth. In this current position, which coastline(s) are experiencing the low spring tides? (5 points) Both W and Y Both X and Z Only W Only X

Both X and Z

Explanation:

In this current position, coastlines which are experiencing the high spring tides are X and Z.

Hope this helps Pls mark as Brainliest!!

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

it is easily magnetized.