Which statement describes an action-reaction pair? A. You push against a wall, and the wall applies a force to your
hands.
B. The Sun pulls on the Earth, and the Earth pulls on the Moon.
C. You push a book off the edge of a shelf, and the book falls to the
floor
G
D. You throw a ball straight up, and Earth's gravity pulls it downward.

You push against a wall, and the wall applies a force to your  hands. (A)

step-by-step explanation:

we are given

we have to simplify it

firstly, we will factor it

now, we can cancel like terms

now, we can combine it

so, we get

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).