Physics, 10.05.2021 20:50 bestsonever698
How does the blade on a jig saw sander move when set to cut straight lines
Answers: 1
Physics, 21.06.2019 19:40
Apackage of supplies is dropped from a plane, and one second later a second package is dropped. neglecting air resistance, the relative velocity of the 1st package viewed from the second will 56) a) increase. b) be constant. c) be zero. d) depend upon their weight. e) decrease
Answers: 1
Physics, 21.06.2019 22:30
Fft review: linspace, fs, fftshift, nfft 1. generate one second of a cosine of w,-10hz sampled at f, = 100hz and assign it to x. define a tt as your time axis 2. take 64 points fft. 3. as you remember, the dft (which the fft implements) computes n samples of s2t where k-0,1,2, n -1. plot the magnitude of this 64-points fft at range 0 to 63, what do you think of this graph? 4â·to get the x-axis into a hz-frequency form, plot this 64-points fft between-50 to 50 (the 100hz sampling rate) and have n-points between them. 5. according to your figure, what frequency is this cosine wave at? 6. remember that the fft is evaluating from 0 to 2ď€. we are used to viewing graphs from-ď€ to ď€. therefore, you need to shift your graph. 7. now according to your shifted graph. what frequency is this at? 8. note that the spikes have long drop-offs? try a 1024-point dft. note that the peak is closer to 10 and the drop-off is quicker. although, now sidelobes are an issue
Answers: 2
Physics, 22.06.2019 12:00
Asolid round steel rod 6.25 mm in diameter and 375 mm long is rigidly bonded to the end of solid square brass rod 25 mm on a side and 300 mm long. the geometric axes of the bare are along the same line. an axial tensile force of 5.4 kn is applied at the extreme ends of the assembly. for steel e = 200 gpa and for brass e = 90 gpa. determine the total elongation for the assembly.
Answers: 1
Physics, 22.06.2019 12:10
Awater slide of length l has a vertical drop of h. abby's mass is m. an average friction force of magnitude f opposes her motion. she starts down the slide at initial speed vi. use work-energy ideas to develop an expression for her speed at the bottom of the slide. then evaluate your result using unit analysis and limiting case analysis. express your answer in terms of the variables h, m, l, vi, f and appropriate constants. vf v f
Answers: 2
How does the blade on a jig saw sander move when set to cut straight lines...
Mathematics, 25.09.2020 07:01
Spanish, 25.09.2020 07:01
English, 25.09.2020 07:01
Mathematics, 25.09.2020 07:01
Mathematics, 25.09.2020 07:01
Social Studies, 25.09.2020 07:01
Physics, 25.09.2020 07:01
Advanced Placement (AP), 25.09.2020 07:01
Mathematics, 25.09.2020 07:01
History, 25.09.2020 07:01
Health, 25.09.2020 07:01
Chemistry, 25.09.2020 07:01