subject
Physics, 27.05.2021 02:50 tee4597

1. When 100 g of a metal at 94° C is placed in 100 g of water at 10° C, the final temperature of the water is 17° C. Calculate the specific heat capacity of the metal.

ansver
Answers: 2

Another question on Physics

question
Physics, 22.06.2019 00:30
Glass is transparent to visibile light under normal conditions; however, at extremely high intensities, glass will absorb most of the light incident upon it. this works through a process known as multiphoton absorption. in this process, several photons are absorbed at the same time. if very intense light whose photons carry 2ev of energy is shined onto a material with a band gap of 4ev, that light can be absorbed through two-photon absorption, because two photons have the right amount of energy to bridge the band gap. what is the minimum number of photons of 800-nm light that are needed to equal or exceed the band gap of fused silica glass
Answers: 1
question
Physics, 22.06.2019 05:30
Explain how the energy of rubber ball is tranforned as it roll down a ramp. give evidence that the energy of the og the ball remains the same at all points on the ramp
Answers: 2
question
Physics, 22.06.2019 19:30
Ashot putter releases the shot some distance above the level ground with a velocity of 12.0 m/s, 51.0 ∘above the horizontal. the shot hits the ground 2.08 s later. you can ignore air resistance. how far did she throw the shot?
Answers: 2
question
Physics, 23.06.2019 07:00
Conventional hot-water heaters consist of a tank of water maintained at a fixed temperature. the hot water is to be used when needed. the drawback is that energy is wasted because the tank loses heat when it is not in use, and you can run out of hot water if you use too much. some utility companies are encouraging the use of on-demand water heaters (also known as flash heaters), which consist of heating units to heat the water as you use it. no water tank is involved, so no heat is wasted. a typical household shower flow rate is 2.50 gal/min (9.46 l/min ) with the tap water being heated from 51.0 ˚f (10.6 ˚c) to 120 ˚f (48.9 ˚c) by the on-demand heater.what rate of heat input (either electrical of from gas) is required to operate such a unit, assuming that all the heat goes into the water?
Answers: 3
You know the right answer?
1. When 100 g of a metal at 94° C is placed in 100 g of water at 10° C, the final temperature of the...
Questions
question
Social Studies, 01.05.2021 22:00
Questions on the website: 13722359