subject
Physics, 11.06.2021 14:00 bezar77

the armature of a 230 V shunt motor has a resistance of 0.18 ohms if the armature current is not to exit 76 a calculate (a) the resistance that must be inserted in series with the armature at the instant of starting​ (b) the value to Wich to the resistance can be reduced when the armature accelerate until Ec is 168 volt (c) the armature current at the instant of starting if no resistance is inserted in the armature circuit. (assume a 2 volt at the brushes)

ansver
Answers: 2

Another question on Physics

question
Physics, 22.06.2019 00:00
How do the measurements of charge at the different locations on the sphere compare to each other? the charge measurements are different at all locations on the sphere. the charge measurements are virtually not the same at all locations on the sphere except for the charge at the very top and at the very bottom that are equal. the charge measurements are virtually the same at all locations on the sphere except for the charge at the very top. at the top, the conductive sphere has a small disk that is made of different material. the charge measurements are the same at all locations on the sphere. what happens to the charge on the conductive sphere when it is connected to a source of charge such as the electrostatic voltage source? nothing will happen because no charge goes around the surface of the sphere. the charge on the conductive sphere spreads out over the surface of the sphere; being greater in some specific locations on the sphere. the charge on the conductive sphere spreads out uniformly over the surface of the sphere. the charge on the conductive sphere spreads out non-uniformly over the surface of the sphere.
Answers: 3
question
Physics, 22.06.2019 04:00
Several mountains together form a mountain . a few of these combined form a mountain system. several systems combined form a mountain , which can stretch thousands of miles in length.
Answers: 2
question
Physics, 22.06.2019 16:50
Calculate the first and second velocities of the car with four washers attached to the pulley, using the formulas v1 = 0.25 m / t1 , and v2 = 0.25 m / (t2 – t1) where t1 and t2 are the average times the car took to reach the 0.25 and the 0.50 meter marks. record these velocities, to two decimal places, in table e.
Answers: 2
question
Physics, 22.06.2019 19:00
Achild has maximum walking speed of 1.6 m/s. what is the length of the child's legs? 0.26 m
Answers: 2
You know the right answer?
the armature of a 230 V shunt motor has a resistance of 0.18 ohms if the armature current is not to...
Questions
question
Mathematics, 24.09.2020 01:01
question
Mathematics, 24.09.2020 01:01
Questions on the website: 13722360