subject
Physics, 03.02.2022 17:40 kayleefaithblair

Based on these results, what can you conclude about the relationship between the initial speed and launch angle?
The higher the initial launch angle, the greater the speed must be to achieve the same
range.
The higher the initial launch angle, the smaller the speed must be to achieve the same
range.
The initial speed and launch angle have no direct relationship.

ansver
Answers: 2

Another question on Physics

question
Physics, 22.06.2019 21:10
Two masses are connected by a rope that hangs over a pulley as shown below. the pulley is a uniform cylinder of radius 푅=0.381meters and mass 푀=3.1푘푔. initially 푚"is on the ground and 푚#rests 2.5 meters above the ground. if the system is released, use conservation of energy to determine the speed of 푚#just before it strikes the ground. assume the pulley bearing is frictionless.
Answers: 2
question
Physics, 23.06.2019 01:00
To practice problem-solving strategy 10.1 for energy conservation problems. a sled is being held at rest on a slope that makes an angle θ with the horizontal. after the sled is released, it slides a distance d1 down the slope and then covers the distance d2 along the horizontal terrain before stopping. find the coefficient of kinetic friction μk between the sled and the ground, assuming that it is constant throughout the trip.
Answers: 1
question
Physics, 23.06.2019 03:10
Galileos view of arrangement of the universe
Answers: 1
question
Physics, 23.06.2019 07:00
Conventional hot-water heaters consist of a tank of water maintained at a fixed temperature. the hot water is to be used when needed. the drawback is that energy is wasted because the tank loses heat when it is not in use, and you can run out of hot water if you use too much. some utility companies are encouraging the use of on-demand water heaters (also known as flash heaters), which consist of heating units to heat the water as you use it. no water tank is involved, so no heat is wasted. a typical household shower flow rate is 2.50 gal/min (9.46 l/min ) with the tap water being heated from 51.0 ˚f (10.6 ˚c) to 120 ˚f (48.9 ˚c) by the on-demand heater.what rate of heat input (either electrical of from gas) is required to operate such a unit, assuming that all the heat goes into the water?
Answers: 3
You know the right answer?
Based on these results, what can you conclude about the relationship between the initial speed and...
Questions
question
English, 22.05.2020 00:10
Questions on the website: 13722367