kaytlyn16

On site since: 2018-03-08 03:45:11

Age: 21 years

About:

Facebook:

Asked questions: 3

Gave answers: 21

Point: 275

Best answer: 2

Questions

question

Engineering, 14.09.2019 02:30

Water at 20 degree celsius enters a 4cm o. d tube 4m long and is heated by stream condensing on the outside of the tube. if the water flow rate is 10/...

question

Engineering, 14.09.2019 02:30

Elaborate on the steps required to specify problems in heat transfer....

question

Engineering, 14.09.2019 02:30

Define elements necessary for establishing symmetry when solving heat transfer problems....

question

Engineering, 14.09.2019 02:30

Describe the physics associated with the concept of thermal resistance....

question

Engineering, 14.09.2019 02:30

For the stress obtained in the previous question, what exactly is this value referring to?...

question

Engineering, 14.09.2019 02:30

Draw a schematic of the lift off process for the diferent resist profiles....

question

Engineering, 14.09.2019 02:30

Briefly describe the operation and use of strain gauges...

question

Engineering, 14.09.2019 02:30

An insulated open feedwater heater (mixing box) is used in a steam power plant to raise the temperature of the water going into the boiler which incre...

question

Engineering, 14.09.2019 02:30

How is the principle of superposition used to determine the stress state for a combined loading?...

question

Engineering, 14.09.2019 02:30

Explain what happens chemically to positive and negative photoresist when exposed to uv radiation....

question

Engineering, 14.09.2019 02:30

How does fouling affects the performance of a heat exchanger?...

question

Engineering, 14.09.2019 02:30

Acoca cola can with a diameter of 65 mm and wall thickness of 400 μm has an intemal pressure of s0 kpa. calculate the principal stresses at a point on...

question

Engineering, 14.09.2019 02:30

Which of the following describes fibers? a)- single crystals with extremely large length-to-diameter ratios. b)- polycrystalline and amorphous materi...

question

Engineering, 14.09.2019 02:30

List four major factors in which ic technology differs from mems or miniaturization science....

question

Engineering, 14.09.2019 02:30

Astrain gauge with a 5 mm gauge length gives a displacement reading of 1.25 um. calculate the stress value given by this displacement if the material...

question

Engineering, 14.09.2019 02:30

What is the governing ratio for thin walled cylinders?...

question

Engineering, 14.09.2019 02:30

What is the significance of saint venant's principle?...

question

Engineering, 14.09.2019 02:30

Explain the basic operation of a plc scan cycle....

question

Engineering, 14.09.2019 02:30

Gaseous propane enters a combustion chamber at 25 °c at a rate of 1.2 kg/min where it is mixed and burned with 150% excess air that enters the combust...

question

Engineering, 14.09.2019 02:30

Acrylonitrile monomer, c3h3n, is an important constituent of acrylic fibers and nitrile rubber. it does not have a cyclic structure and it has only on...