When was the last san andreas earthquake

the last time that there was an earthquake there was in 1895! that was a long time ago! it was one of the most devastating earthquakes in america! The San Andreas Fault is a continental transform fault that extends roughly 1,200 kilometers (750 mi) through California.[1] It forms the tectonic boundary between the Pacific Plate and the North American Plate, and its motion is right-lateral strike-slip (horizontal). The fault divides into three segments, each with different characteristics and a different degree of earthquake risk. The slip rate along the fault ranges from 20 to 35 mm (0.79 to 1.38 in 1895 as I said before!

The fault was identified in 1895 by Professor Andrew Lawson of UC Berkeley, who discovered the northern zone. It is often described as having been named after San Andreas Lake, a small body of water that was formed in a valley between the two plates. However, according to some of his reports from 1895 and 1908, Lawson actually named it after the surrounding San Andreas Valley. Following the 1906 San Francisco earthquake, Lawson concluded that the fault extended all the way into southern California.

you must remain stopped until the stop signal is retracted and the red lights are turned off. approaching traffic in the opposite roadway of a divided highway shall not be required to stop, even if the school bus has the stop-arm extended and the alternately flashing warning signal lamps on.

the cell cycle is the final answer! : )