Questions on Engineering

subject
Engineering, 31.07.2021 09:40
Calculate the current in the 8-W resistor of Figure below by using Thevenin’s theorem. What will be its value of connections of 6V battery are reversed
subject
Engineering, 31.07.2021 08:10
Phân tích những đặc điểm khác nhau cơ bản về nguyên lý hoạt động của động cơ diesel 4 kỳ và động diesel 2 kỳ ?...
subject
Engineering, 31.07.2021 07:50
Vẽ sơ đồ cấu tạo , đồ thị công chỉ thị và mô tả nguyên lý hoạt động của động cơ xăng 4 kỳ...
subject
Engineering, 31.07.2021 05:00
When the rod is circular, radial lines remain straight and sections perpendicular to the axis do not warp. In this case, the strains vary linearly along radial lines. Within the proportional limit, th...
subject
Engineering, 31.07.2021 04:50
¿Qué diferencias encuentra Ud. Entre los agregados y los materiales finos que pasan la malla N°200?...
subject
Engineering, 31.07.2021 04:30
If the tank is designed to withstand a pressure of 5 MPaMPa, determine the required minimum wall thickness to the nearest millimeter using the maximum-shear-stress theory. Apply a factor of safety of...
subject
Engineering, 31.07.2021 04:30
Adits are a. the vertical shafts that go deep into a mine to reach to the depth at which ore is found. b. piles of mine tailings that are sprayed with acid to release more metal ore. c. the machines u...
subject
Engineering, 31.07.2021 04:30
A steam turbine generator unit is used to produce electricity, where steam enters the turbine with a velocity of 30 m/s and enthalpy (internal energy) of 3348 kJ/kg. The 1 steam leaves the turbine as...
subject
Engineering, 31.07.2021 04:20
Write the different professions and human resources related to engineering and expalin any two of them?...
subject
Engineering, 31.07.2021 03:20
Both high-side pressures and low-side pressures are low with the engine running and the selector set to the air conditioning position. Technician A says that the system is undercharged. Technician B s...
subject
Engineering, 31.07.2021 02:30
A cylindrical piece of steel 75 mm (3 in.) in diameter is to be austenitized and quenched such that a minimum hardness of 40 HRC is to be produced throughout the entire piece. Of the alloys 8660, 8640...
subject
Engineering, 31.07.2021 01:40
Anyone is here I m talking to u all guys​...
subject
Engineering, 30.07.2021 20:50
A man loans P 187,400 from a bank with interest at 5% compounded annually. He agrees to pay his obligations by paying 8 equal annual payments, the first being due at the end of 10 years. Find the annu...
subject
Engineering, 30.07.2021 20:30
A moving-coil instrument, which gives full-scale deflection with 0.015 A has a copper coil having resistance of 1.5 Ohm at 15°C and a temperature coefficient of 1/234.5 at 0 degree C in series with a...
subject
Engineering, 30.07.2021 20:20
Mr. David deposits Rs 1200 now, Rs 800 two years from now and Rs 1000 five years from now. If the savings bank's rate of interest in 5%, he will receive an amount of Rs X, 10 years from now, where ‘X’...
subject
Engineering, 30.07.2021 19:20
2. A general needs to take his troops across the river. He spies two boys with a small boat. He commandeers both the boat and the boys. Unfortunately, the boat will only hold two boys or one soldier....
subject
Engineering, 30.07.2021 18:10
Oto có khối lượng m(kg) đạt tại trọng tâm H. Khoảng cách từ H tới 2 bánh xe hai bên của a (m) và b(m) . Khoảng cách vết bánh xe AB = L(m) . Oto không bị trượt ngang a , bán kính quay vòng r(m) vận tốc...
subject
Engineering, 30.07.2021 17:50
The motion of a bob of a pendulum can be descibed by O= -5 cos(2 t) - 2 sin(2 t) where ө e is the angle made by the bob and pendulum for time, t, in seconds. Write e in the form Rcos (2t-B) gives A 5....
subject
Engineering, 30.07.2021 17:30
Điều kiện để ngành bán lẻ vận hành tốt là gì?...
subject
Engineering, 30.07.2021 17:10
Giải pháp giảm chi phí điện nước...
More questions
See results (0)