Explanation:
Simple layering can be accomplished by bending a low growing, flexible stem to the ground. Cover part of it with soil, leaving the remaining 6 to 12 inches above the soil. Bend the tip into a vertical position and stake in place (Figure 1). The sharp bend will often induce rooting, but wounding the lower side of the bent branch may help also. Simple layering can be done on most plants with low-growing branches. Examples of plants propagated by simple layering include climbing roses, forsythia, rhododendron, honeysuckle, boxwood, azalea, and wax myrtle.
Tip Layering
Skip to Tip Layering
Tip layering is quite similar to simple layering. Dig a hole 3 to 4 inches deep. Insert the tip of a current season’s shoot and cover it with soil. The tip grows downward first, then bends sharply and grows upward. Roots form at the bend. The re-curved tip becomes a new plant (Figure 2). Remove the tip layer and plant it in late fall or early spring. Examples of plants propagated by tip layering include purple and black raspberries, and trailing blackberries.
Compound (serpentine) Layering
Skip to Compound (serpentine) Layering
Compound (serpentine) layering is similar to simple layering, but several layers can result from a single stem. Bend the stem to the rooting medium as for simple layering, but alternately cover and expose sections of the stem. Each section should have at least one bud exposed and one bud covered with soil. Wound the lower side of each stem section to be covered (Figure 3). This method works well for plants producing vine-like growth such as heart-leaf philodendron, pothos, wisteria, clematis, and grapes.
Mound (stool) Layering
Skip to Mound (stool) Layering
Mound (stool) layering is useful with heavy-stemmed, closely branched shrubs and rootstocks of tree fruits. Cut the plant back to 1 inch above the soil surface in the dormant season. Dormant buds will produce new shoots in the spring. Mound soil over the new shoots as they grow (Figure 4). Roots will develop at the bases of the young shoots. Remove the layers in the dormant season. Mound layering works well on apple rootstocks, spirea, quince, daphne, magnolia, and cotoneaster.
Air Layering
Skip to Air Layering
Air layering can be used to propagate large, overgrown house plants such as rubber plant, croton, or dieffenbachia that have lost most of their lower leaves. Woody ornamentals such as azalea, camellia, magnolia, oleander, and holly can also be propagated by air layering. For optimum rooting, make air layers in the spring on shoots produced during the previous season or in mid to late summer on shoots from the current season’s growth. For woody plants, stems of pencil size diameter or larger are best. Choose an area just below a node and remove leaves and twigs on the stem 3 to 4 inches above and below this point. This is normally done on a stem about 1 foot from the tip.
Air layering differs, depending on whether the plant is a monocot or a dicot. For monocots, make an upward 1- to 11⁄2-inch cut about one-third through the stem. The cut is held open with a toothpick or wooden match stick. Surround the wound with moist, unmilled sphagnum moss (about a handful) that has been soaked in water and squeezed to remove excess moisture. Wrap the moss with plastic and hold in place with twist ties or electrician’s tape. No moss should extend beyond the ends of the plastic. Fasten each end of the plastic securely, to retain moisture and to prevent water from entering. If exposed to the sun, the plastic should be covered. Aluminum foil can also be used, as it does not require twist ties or tape to hold it in place.
Natural Forms of Layering
Skip to Natural Forms of Layering
Sometimes layering occurs naturally, without the assistance of a propagator. Runners and offsets are specialized plant structures that facilitate propagation by layering.