Noble gas compounds like krf, xecl, and xebr are used in excimer lasers. draw an approximate molecular orbital diagram appropriate for these molecules (they will be quite similar). give the ground-state electron configuration of krf and predict whether the cationic analog (krf) is likely to have a stronger bond.

Here's what I get.

Explanation:

The MO diagrams of KrBr, XeCl, and XeBr are shown below.

They are similar, except for the numbering of the valence shell orbitals.

Also, I have drawn the s and p orbitals at the same energy levels for both atoms in the compounds. That is obviously not the case.

However, the MO diagrams are approximately correct.

The ground state electron configuration of KrF is

KrF⁺ will have one less electron than KrF.

You remove the antibonding electron from the highest energy orbital, so the bond order increases.

The KrF bond will be stronger.

Note that 2 mol dm⁻³ = 2 mol/(dm³)outline: we're given the concentration of hcl, which is  2 mol dm⁻³ (cubic meters in the denominator can represent volume, so i know this is concentration). we're an amount of calcium carbonate caco₃, which is 5 g. we're presented with a chemical equation which includes caco₃ and hcl. we are told to find the volume of hcl. from what we see so far, this seems to be a stoichiometry  problem. we'll have to use the given information about calcium carbonate to find the amount of moles of hcl needed to fully react with calcium carbonate. then we'll have information about the moles of hcl and the concentration of hcl; that will be enough to figure out volume according to the formula concentration = moles / volume.======all the answer choices are not in dm.convert the given concentration so that it uses cm⁻³.we can use conversion factors. we have to cube our conversion factors so that dimensional analysis works.we can convert to meters first, using the fact that     10 dm = 1 m  ⇔ 10³ dm³ = 1 m³then we use the fact that     10² cm = 1 m ⇔ (10² cm)³ = (1 m)³ ⇔ 10⁶ cm³ = 1 m³so converting:     now we have to find the moles of hydrochloric  acid neededfind the moles of calcium carbonate. we have to find the molar mass of calcium carbonate, caco₃, which can be found by    molar mass = (mass ca) + (mass c) + 3(mass o)    = 40 + 12 + 3(16)    = 100 g/molconvert the given 5 g to moles:     mol caco₃ = 5 g caco₃ * 1 mol/(100 g) = 0.05 mol caco₃use stoichiometry (ratios) to figure out the moles of hcl needed. ratio wise, there's 2 hcls for every caco₃, so use dimensional analysis    mol hcl = mol caco₃ * (2 mol hcl) / (1 mol caco₃)    = 0.05 mol hcl * 2    = 0.1 mol hcl  we have 0.1 mol hcl and concentration of hcl (0.002 mol/cm³).we need to find volumesince concentration = moles / volume, rearrange to get     volume = moles / concentration    volume = 0.1 mol / (0.002 mol/cm³)    volume = 50 cm³

The disturbance is only parallel to the motion of the wave.