Chemistry, 11.12.2019 04:31 GreenHerbz206

Technician a says that a maf sensor actually measures the density and amount of air flowing into the engine. technician b says a that hot wire maf sensor uses the electronics in the sensor itself to heat a wire 70°c above the temperature of the air entering the engine. who is right?

Answers: 2

Show answers

Another question on Chemistry

Chemistry, 22.06.2019 08:00

Will give ! what are the advantages and disadvantages of nuclear power? check all that apply. one advantage of nuclear energy is that it does not produce carbon dioxide emissions. storage of nuclear waste is a short-term problem associated with nuclear energy. the problem with uranium mining is that a large quantity of uranium must be extracted to meet energy needs because the energy release from uranium fission is so low. safe operation of a nuclear power plant can be jeopardized by a human mistake.

Answers: 1

Answer

Chemistry, 22.06.2019 14:00

The content of manganese (mn) in steel was determined spectrophotometrically and with the use of the standard addition method. an unknown sample of mn from a digested steel sample gave an absorbance of 0.185 when analyzed spectrophotometrically. when 5.00 ml of solution containing 95.5 ppm mn was added to 50.0 ml of the unknown steel solution (digested sample), the absorbance was 0.248. calculate the concentration, in parts-per-million (ppm), of mn in the digested steel sample solution.

Answers: 3

Answer

Chemistry, 22.06.2019 22:30

Gusing the milligrams of ascorbic acid you entered above, the ratio of total sample volume to aliquot volume, and the total milligrams of the vitamin c tablet that you dissolved, calculate the mass of ascorbic acid in the vitamin c tablet for each trial. do this by scaling up to find the amount (mg) of ascorbic acid in your 250 ml flask. enter your calculated mass of ascorbic acid in the vitamin c tablet, for each trial. be sure to enter your calculated mass in the corresponding order that you entered your milligrams of ascorbic acid. the milligrams of ascorbic acid you entered for entry #1 previously should correspond to the mass of ascorbic acid that you enter for entry #1 here.

Answers: 1

Answer

Chemistry, 23.06.2019 00:30

What is the percent by mass of magnesium sulfate in mgso4.7h2o

Answers: 3

Answer

You know the right answer?

Technician a says that a maf sensor actually measures the density and amount of air flowing into the...

Questions