Chemistry, 09.07.2020 01:01 KRAL165

Balance the following: 1. Potassium phosphate + magnesium oxide → magnesium phosphate + potassium oxide 2. Ammonia (NH3) + oxygen → nitrogen + water 3. Sodium chloride + sulfuric acid (H2SO4) → sodium sulfate + hydrochloric acid (HCl) 4. Fluorine + sodium hydroxide → sodium fluoride + oxygen + water 5. Magnesium nitrate + calcium iodide → calcium nitrate + magnesium iodide 6. Aluminum sulfate + ammonium bromide → aluminum bromide + ammonium sulfate 7. Potassium fluoride + barium bromide → barium fluoride + potassium bromide 8. Copper (II) nitrate + ammonium hydroxide → copper (II) hydroxide + ammonium nitrate 9. Sodium nitrate → sodium nitrite + oxygen 10. Lead (II) hydroxide → lead (II) oxide + water 11. Ammonia (NH3) + sulfuric acid (H2SO4) → ammonium sulfate 12. Hydrochloric acid (HCl) + ammonia (NH3) → ammonium chloride 13. Copper (II) sulfate + iron → iron (II) sulfate + copper

Answers: 3

Show answers

Another question on Chemistry

Chemistry, 20.06.2019 18:04

Two liquids are shaken together in a test tube to produce a mixture that quickly separates into two layers. which of the following best describes the behavior of the above pair of substances? soluble insoluble miscible immiscible

Answers: 1

Answer

Chemistry, 22.06.2019 01:00

What are the genotypic and phenotypic ratios

Answers: 2

Answer

Chemistry, 22.06.2019 05:30

A3.37-mg sample of protein was chemically digested to convert its nitrogen into ammonia and then diluted to 100.0 ml. then 10.0 ml of this solution was placed in a 50-ml volumetric flask and treated with 5 ml of phenol solution plus 2 ml of sodium hypochlorite solution. the sample was diluted to 50.0 ml, and the absorbance at 625 nm was measured in a 1.00-cm cuvette and found to be 0.486. for reference, a standard solution was prepared from 10.0 mg of nh4cl (molar mass = 53.49 grams/mole) dissolved in 1.00 l of water. then 10.0 ml of this standard was placed in a 50-ml volumetric flask, treated in the same manner as the unknown, and the absorbance found to be 0.323. finally, a reagent blank was prepared using distilled water in place of unknown, it was treated in the same manner as the unknown, and the absorbance found to be 0.076. calculate the weight percent of nitrogen in the protein.

Answers: 1

Answer

Chemistry, 22.06.2019 16:00

1. an experiment in your science class lists the materials needed for the lab. it is your job, as a lab partner, to measure out 25 ml of distilled water and 2.5 grams of magnesium. what lab measuring tools would you choose to measure each substance and how would you use each tool to get the correct amounts? be sure to describe the process you would follow step-by-step. (5 points) 2.which of the following is an si base unit for measuring mass? (2 points) ampere gram meter pound 3.which of the following is an si base unit for time? (2 points) decades hours minutes seconds 4.which of the following tools should a scientist use to measure an object in milligrams? (2 points) graduated cylinder pan balance tape measure thermometer 4.which of the following tools should a scientist use to measure an object in milligrams? (2 points) graduated cylinder pan balance tape measure thermometer. 5.a pencil beside a metric ruler. the ruler is scaled from 1 centimeter to 10 centimeters, with markings for millimeters between each number. one end of the pencil is beside the 0 on the ruler, and the pencil point is beside the 5. which of the following measurements is accurate but not precise? (2 points) 5 mm 5 cm 50 mm 50 cm 6. which of the following prefixes represents the largest value? (2 points) giga hector kilo milli 7. which of the following types of graphs is best for plotting the percentages of a whole value in a data set? (2 points) bar graph circle graph histogram line graph

Answers: 1

Answer

You know the right answer?

Balance the following: 1. Potassium phosphate + magnesium oxide → magnesium phosphate + potassium ox...

Questions