If you needed a 1.5 x 1 0-4 M solution of a compound that has a molar mass of 760 g/mol, what would it concentration be in parts per million?

114 ppm

Explanation:

Data obtained from the question include:

Conc. of compound in mol/L = 1.5×10¯⁴ mol/L

Molar mass of compound = 760 g/mol

Conc. in ppm =..?

Next, we shall determine the concentration of the compound in grams per litre (g/L) . This is illustrated below:

Conc. in mol/L = conc. in g/L / Molar mass

1.5×10¯⁴ = conc. In g/L / 760

Cross multiply

Conc. in g/L = 1.5×10¯⁴ x 760

Conc. in g/L = 0.114 g/L

Next, we shall convert 0.114 g/L to milligrams per litre (mg/L). This is illustrated below:

1 g/L = 1000 mg/L

Therefore, 0.114 g/L = 0.114 x 1000 = 114 mg/L

Finally, we shall convert 114 mg/L to parts per million (ppm). This is illustrated below:

1 mg/L = 1 ppm

Therefore, 114 mg/L = 114 ppm

From the calculations made above,

1.5×10¯⁴ mol/L Is equivalent to 114 ppm.

assuming that your periodic table has eighteen columns, you should highlight   the four elements in the third column from the left of the table.

neutral atoms of elements after calcium contain d electrons. the energy of d orbitals of a particular main shell lies between the energy of the s and p orbitals of the next main shell. for example, electrons in the have energy higher than those in the orbital while lower than those of the orbital.

by the aufbau principle, electrons fill orbitals one at a time, starting from those of the lowest energy. the orbital is therefore filled right after orbitals and before orbitals.  

potassium has electron configuration and calcium . the s orbital of a main shell holds a maximum of two electrons. the next element would thus have the electron configuration and satisfy the requirements.

a neutral atom of the element contains three electrons on top of the most recent noble gas element. it should thus be placed in the third column of the periodic table. both scandium and yttrium would satisfy the conditions. an aufbau diagram indicates that the 4f orbital is filled before the 5d. however, it appears that exceptions exists for both lanthanum and actinium. neutral atoms of the two d-block elements also demonstrate the and should be highlighted as well.