Chemistry, 11.11.2020 22:00 hosfordkenya4

Explain the correlation between chemical properties and chemical changes. (plz i not sure on the answer so it would mean a lot if you could help me.)

Answers: 3

Show answers

Answers

Answer from: playboib

Explanation:

A chemical property describes the ability of a substance to undergo a specific chemical change.

A chemical reaction is a process that occurs when one or more substances are changed into one or more new substances.

Differences

Chemical properties are properties that can be observed or measured when a substance undergoes a chemical change.

Physical properties are properties that can be observed without bringing a chemical change.

Another one

chemical properties; can be used to predict how substances react.

chemical changes; It is mostly used in identifying or describing the substance.

Answer from: 240662

A chemical property is any of a material's properties that becomes evident during, or after, a chemical reaction; that is, any quality that can be established only by changing a substance's chemical identity.[1] Simply speaking, chemical properties cannot be determined just by viewing or touching the substance; the substance's internal structure must be affected greatly for its chemical properties to be investigated. When a substance goes under a chemical reaction, the properties will change drastically, resulting in chemical change.

Chemical changes occur when a substance combines with another to form a new substance, called chemical synthesis or, alternatively, chemical decomposition into two or more different substances. These processes are called chemical reactions and, in general, are not reversible except by further chemical reactions.

hope this helps!

Answer from: Quest

a 20-cm-long, cylindrical graphite (pure carbon) rod is inserted into an oxidizing atmosphere at 1145 k and 1.013 x 105 pa pressure. the oxidizing process is limited by the diffu- sion of oxygen counterflow to the carbon monoxide that is formed on the cylindrical surface.

Answer from: Quest

The activity series is shown in the attached picture. if the element is below the other, then you can displace the other. following the activity series as a guide, the reactions are as follows: nickel and aluminum chloride3 ni + 2 alcl₃ → 3 nicl₂ + 2 albarium and copper bromideba + cubr → no reaction because cu is less oxidizable than bapotassium nitrate and aluminum3 kno₃ + al → al(no₃)₃ + 3 ksodium phosphate and zincnaso₄ + zn → znso₄ + na

Another question on Chemistry

Chemistry, 22.06.2019 05:30

Transportation is the largest single source of air pollution in the united states. air pollution can harm the environment and human health. which technology could offer a solution to this problem? mufflers that reduce noise motors that run on electricity tires that improve gas mileage

Answers: 3

Answer

Chemistry, 23.06.2019 03:00

Achemical equilibrium between gaseous reactants and products is shown. n2(g) + 3h2(g) ⇌ 2nh3(g) how will the reaction be affected if the pressure on the system is increased? it will shift toward the reactant side as there is lower pressure on the reactant side. it will shift toward the product side as there is higher pressure on the product side. it will shift toward the reactant side as there are a greater number of moles of gas on the reactant side. it will shift toward the product side as there are a fewer number of moles of gas on the product side.

Answers: 2

Answer

Chemistry, 23.06.2019 07:40

)in the deacon process for the manufacture of chlorine, hcl and o2 react to form cl2 and h2o. sufficient air (21 mole% o2, 79% n2) is fed to provide 35% excess oxygen, and the fractional conversion of hcl is 85%. calculate the mole fractions of the product stream components.

Answers: 1

Answer

Chemistry, 23.06.2019 09:10

Complete the following radioactive decay problem. tan+on-? c+th

Answers: 1

Answer

You know the right answer?

Explain the correlation between chemical properties and chemical changes. (plz i not sure on the ans...

Questions