Dominic made the table below to organize his notes about mixtures. A 1-column table. The first column labeled properties of mixtures has entries has no set composition, must have more than one state of matter, must have more than one substance. What mistake did Dominic make? The title should read “Properties of Solutions” because some mixtures do not have all of the properties listed. There is a definite recipe to make each mixture, so the composition of a mixture is set. Although it is possible to have more than one state, it is also possible to have only one state. A single substance can be used to make a mixture if the substance is composed of more than one element.

A3.37-mg sample of protein was chemically digested to convert its nitrogen into ammonia and then diluted to 100.0 ml. then 10.0 ml of this solution was placed in a 50-ml volumetric flask and treated with 5 ml of phenol solution plus 2 ml of sodium hypochlorite solution. the sample was diluted to 50.0 ml, and the absorbance at 625 nm was measured in a 1.00-cm cuvette and found to be 0.486. for reference, a standard solution was prepared from 10.0 mg of nh4cl (molar mass = 53.49 grams/mole) dissolved in 1.00 l of water. then 10.0 ml of this standard was placed in a 50-ml volumetric flask, treated in the same manner as the unknown, and the absorbance found to be 0.323. finally, a reagent blank was prepared using distilled water in place of unknown, it was treated in the same manner as the unknown, and the absorbance found to be 0.076. calculate the weight percent of nitrogen in the protein.