Chemistry, 26.02.2021 22:40 SmokeyRN

These supplies are needed: distilled water
0.1 M HCl (8.3 mL concentrated HCl per 1 L of solution)
CAUTION: WEAR GOGGLES! HANDLE CONCENTRATED ACIDS UNDER ADULT SUPERVISION IN AN AREA WITH ADEQUATE VENTILATION. ALWAYS ADD ACID TO THE PRE-MEASURED WATER.
0.001 M HCl (1 mL 0.1 M HCl per 100 mL of solution)
0.00001 M HCl (1 mL 0.001 M HCl per 100 mL of solution)
marble, limestone, or chalk chips
pipette (glass with suction bulb or disposable)
4 test tubes
goggles
Follow these directions and complete the activities.

Set up four test tubes in a rack.
Add a small marble chip to each of the test tubes.
Add 1 mL samples of acid solutions as labeled in the chart.
Start with the weakest solution (distilled water) and work your way up in concentration. In this manner, you may use a single pipette for the entire experiment. Each test solution will simply increase the density of ions added to the chalk. Can you understand why you cannot return to a weaker solution with the same pipette?
Observe whether reaction takes place and how fast. Record your results.
Pour the acid solution from each test tube into the sink.
Rinse the marble chips with water and place them in a container for this purpose to be used again.
Observations:

Data Table:

distilled water 0.0001M HCl 0.001 M HCl 0.1 M HCl
strength of reaction
speed of reaction
Analysis:

Marble is made from limestone under the influence of heat and pressure. The chemical formula for limestone or marble chips is CaCO3. When you added the chips to the acid solutions, they effervesced (bubble or foam).

What is the gas that is produced?
What is the chemical formula of the gas?
How could you test rocks for the presence of limestone?
Write a balanced symbol model for the reaction of limestone with hydrochloric acid.

Answers: 1

Show answers

Another question on Chemistry

Chemistry, 21.06.2019 20:30

Hannah is writing a report on how albedo affects the global climate. she’s proofreading her passage for any factual errors. which sentence must hannah correct before submitting her report? earth receives energy from the sun. this energy drives many of the processes on earth, including its climate. some part of this energy is reflected by earth’s surface. we use the term albedo to describe the reflected energy. albedo of an object is the ratio of the reflected radiation to the total radiation reaching the object. a value of 0 means no energy is absorbed by the object, whereas a value of 1 means that all of the energy is absorbed. in this way, the albedo of an object can influence earth’s atmospheric temperature.

Answers: 1

Answer

Chemistry, 22.06.2019 07:20

Describing intermolecular forces use the drop down menus to match the type of intermolecular force to its name dipole dipole interactions dipole induced dipole interactions london dispersion forces hydrogen bond van der waals forces done

Answers: 1

Answer

Chemistry, 22.06.2019 09:00

What type of energy do chemical bonds have? what type of energy is it converted to during chemical reactions? question 15 options: chemical bonds have kinetic energy, which is converted to potential energy during chemical reactions. chemical bonds have electric energy, which is converted to potential energy during chemical reactions. chemical bonds have heat energy, which is converted to kinetic energy during chemical reactions. chemical bonds have potential energy, which is converted to heat energy during chemical reactions.

Answers: 1

Answer

Chemistry, 22.06.2019 18:00

Which statement best describes the he properties of iconic compounds ?

Answers: 1

Answer

You know the right answer?

These supplies are needed: distilled water
0.1 M HCl (8.3 mL concentrated HCl per 1 L of solu...

Questions