Chemistry, 07.10.2019 22:40 abbyheule1440

Energy increases heat and causes a phase change from solid to liquid or liquid to solid

Answers: 1

Show answers

Answers

So, how could there be a change in heat during a state change without a change in temperature? During a change in state the heat energy is used to change the bonding between the molecules. In the case of melting, added energy is used to break the bonds between the molecules. In the case of freezing, energy is subtracted as the molecules bond to one another. These energy exchanges are not changes in kinetic energy. They are changes in bonding energy between the molecules.If heat is coming into a substance during a phase change, then this energy is used to break the bonds between the molecules of the substance. The example we will use here is ice melting into water. Immediately after the molecular bonds in the ice are broken the molecules are moving (vibrating) at the same average speed as before, so their average kinetic energy remains the same, and, thus, their Kelvin temperature remains the same.

Below is a picture of solid ice melting into liquid water. The molecule of ice and the molecule of water (the black balls) are moving with the same rate of vibration in this diagram. This is meant to show that they have the same average speed and thus the same average kinetic energy (since they have the same mass) and thus the same Kelvin temperature. The motions are, though, greatly exaggerated. Actually, the motions of the molecules should be considered tiny vibrations.

Answer from: Quest

when the volume of gas is changed from 717.73 ml to 852 ml the temperature will change from 315 c to 452 c

calculation

this is calculated using the charles law formula

that is, v1/t1 = v2/t2

v1=?

t1 = 315 c into kelvin = 315 +273 = 588 k

v2 = 852 ml

t2 = 425c + 273 =698 k

make v1 the subject of the formula ( by multiplying both side by t1)

v1=( v2 xt1) / t2

v1= (852 ml x 588 k)/ 698 k= 717.73 ml

Answer from: Quest

D.na is the answer hope this

Another question on Chemistry

Chemistry, 22.06.2019 14:30

Calculate the mass of carbon in 97.0 g of sucrose c12h22o11

Answers: 3

Answer

Chemistry, 22.06.2019 18:30

Which sample at stp has the same number of atoms as 18 liters of ne at stp

Answers: 1

Answer

Chemistry, 22.06.2019 20:40

What effect would average population growth have on land usage? a. urban use of land would rise to more than 30 percent of available land. b. industrial use of land would rise to more than 30 percent of available land. c. the percentage of available land used as cropland would stay the same. d. cropland would fall to about 10 percent of available land.

Answers: 1

Answer

Chemistry, 22.06.2019 22:30

Gusing the milligrams of ascorbic acid you entered above, the ratio of total sample volume to aliquot volume, and the total milligrams of the vitamin c tablet that you dissolved, calculate the mass of ascorbic acid in the vitamin c tablet for each trial. do this by scaling up to find the amount (mg) of ascorbic acid in your 250 ml flask. enter your calculated mass of ascorbic acid in the vitamin c tablet, for each trial. be sure to enter your calculated mass in the corresponding order that you entered your milligrams of ascorbic acid. the milligrams of ascorbic acid you entered for entry #1 previously should correspond to the mass of ascorbic acid that you enter for entry #1 here.

Answers: 1

Answer

You know the right answer?

Energy increases heat and causes a phase change from solid to liquid or liquid to solid...

Questions