Chemistry, 19.10.2019 11:50 mqturner1989Kedie

What is the the device used to measure the average kinetic energy of the particles in a substance

Answers: 2

Show answers

Another question on Chemistry

Chemistry, 22.06.2019 13:00

These questions are based on the attached photo. the experiment is about burning magnesium metal with oxygen. 1. write the balanced chemical equation for the reaction you are performing. 2. calculate the mass of magnesium metal used in each trial. o trial 1: o trial 2: 3. calculate the actual yield of magnesium oxide for each trial. o trial 1: o trial 2: 4. magnesium is the limiting reactant in this experiment. calculate the theoretical yield of mgo for each trial. o trial 1: o trial 2: 5. determine the percent yield of mgo for your experiment for each trial. o trial 1: o trial 2: 6. determine the average percent yield of mgo for the two trials. your company currently uses a process with a similar cost of materials that has an average percent yield of 91 percent. if the average percent yield of this process is higher than that, this could save the company money. what is your recommendation to the company? support your recommendation using your data, calculations, and understanding of stoichiometry gathered from this lab.

Answers: 1

Answer

Chemistry, 22.06.2019 13:00

Asubstance is a good conductor of electricity which of the following best explains a probable position of the substance in a periodic table

Answers: 3

Answer

Chemistry, 22.06.2019 22:30

What methods could you use to solubilize calcium carbonate

Answers: 1

Answer

Chemistry, 22.06.2019 23:10

Amines are good nucleophiles, even though they are neutral molecules. how would the rate of an sn2 reaction between an amine and an alkyl halide be affected if the polarity of the solvent is increased? amines are good nucleophiles, even though they are neutral molecules. how would the rate of an reaction between an amine and an alkyl halide be affected if the polarity of the solvent is increased? because both reactants in the rate-limiting step are neutral, the reaction will be faster if the polarity of the solvent is increased. because both reactants in the rate-limiting step are neutral, the reaction will be slower if the polarity of the solvent is increased. because both reactants in the rate-limiting step are neutral, the reaction will occur at the same rate if the polarity of the solvent is increased. request answer

Answers: 3

Answer

You know the right answer?

What is the the device used to measure the average kinetic energy of the particles in a substance...

Questions