Chemistry, 21.04.2021 03:20 MrConman8460

What is the pH of a solution that has a hydrogen ion concentration of 6.9*10^-4?

Answers: 3

Show answers

Answers

Answer from: Quest

assuming that your periodic table has eighteen columns, you should highlight the four elements in the third column from the left of the table.

explanation

neutral atoms of elements after calcium contain d electrons. the energy of d orbitals of a particular main shell lies between the energy of the s and p orbitals of the next main shell. for example, electrons in the $3d$ have energy higher than those in the $4 s$ orbital while lower than those of the $4 p$ orbital.

by the aufbau principle, electrons fill orbitals one at a time, starting from those of the lowest energy. the $4s$ orbital is therefore filled right after $3p$ orbitals and before $3 d$ orbitals.

potassium has electron configuration $[\text{ar}] 4 s^{1}$ and calcium $[\text{ar}] 4 s^{2}$ . the s orbital of a main shell holds a maximum of two electrons. the next element would thus have the electron configuration $[\text{ar}] 4 s^{2} \; 3d^{1}$ and satisfy the requirements.

a neutral atom of the element contains three electrons on top of the most recent noble gas element. it should thus be placed in the third column of the periodic table. both scandium and yttrium would satisfy the conditions. an aufbau diagram indicates that the 4f orbital is filled before the 5d. however, it appears that exceptions exists for both lanthanum and actinium. neutral atoms of the two d-block elements also demonstrate the $ns^{2} \; (n-1) p^{1}$ and should be highlighted as well.

Answer from: Quest

aquifers are bounded above and below by impermeable rock. the driving force of groundwater movement in confined aquifers is pressure, rather than gravity.

Answer from: Quest

they it depends on if one believes about radioactivity, they make a geiger counter beep but maybe it was going to beep anyway electronics do wierd things all the time or it was programmed to beep near certain metals.

Answer from: Quest

nacl or sodium chloride is an ionic compound. this is because an ionic compound pertains to a compound that consists of positively and negatively charged ions. in this case, na (sodium) has a tendency to lose one electron when it reacts with with other atoms, so the resulting sodium ion contains 11 protons and 10 electrons, thus making it positively charged (na+), when chlorine reacts, it usually gains one electron to form an ion called chloride, thus making it negatively charged ( since the ions are oppositely charged, they attract.

Another question on Chemistry

Chemistry, 22.06.2019 10:30

Consider the following reactions. (note: (s) = solid, (l) = liquid, and (g) = gas.) mg(s) + ½o2(g) → mgo(s) + 146 kcal/mole h2(g) + ½o2(g) → h2o(g), δh = -57.82 kcal/mole what type of reaction is represented by the previous two examples?

Answers: 3

Answer

Chemistry, 22.06.2019 11:00

When hydrochloric acid reacts with potassium hydroxide solution, the following reaction occurs. hcl (aq) + koh (aq) h2o (l) + kcl (aq) the reaction gives off heat energy, so it is an reaction.

Answers: 1

Answer

Chemistry, 23.06.2019 01:00

Who examines and coordinates the cleanup of polluted sites?

Answers: 2

Answer

Chemistry, 23.06.2019 09:30