Chemistry, 24.06.2021 01:00 pat930

3. To what Celsius temperature does 750. mL of gas originally at −12°C need to be heated to bring the volume to 2.10 L? 4. The pressure in a car tire is 217 kPa at 24°C. After being driven on a hot summer day, the pressure in the tire increases to 258 kPa. What is the Celsius temperature of the air in the tire?
5. A gas sample originally at −39°C is heated to standard temperature (0°C), at which point its pressure is measured to be 808 mmHg. What was the original pressure of the gas?
6. A 400. mL sample of gas at 15°C and 113 kPa is heated to 227°C while expanding into a 900. mL container. What is the new pressure of the gas in kPa?
7. 2.50 g of CO2 gas is confined in a rigid cylinder at a pressure of 4.65 atm. If 0.42 g of gas is released from the cylinder, what is the new pressure?

Answers: 1

Show answers

Another question on Chemistry

Chemistry, 22.06.2019 09:30

The chart shows the bid provided by four contractors to complete a job. which contractor is the most cost-effective?

Answers: 3

Answer

Chemistry, 22.06.2019 16:40

Let the ed50 of a recreational drug be defined as the amount required for 50% of a test group to feel high or get a buzz. if the ed50 value of ethanol is 470 mg/kg body mass, what dose would a 70 kg party goer need to quickly consume in order to have a 50% chance of getting a buzz? 235 mg 470 mg 32,900 mg 35,000,000 mg

Answers: 3

Answer

Chemistry, 22.06.2019 17:10

)benzene and toluene form nearly ideal solutions. consider an equimolar solution of benzene and toluene. at 20 °c the vapour pressures of pure benzene and toluene are 9.9 kpa and 2.9 kpa, respectively. the solution is boiled by reducing the external pressure below the vapour pressure. calculate (i) the pressure when boiling begins, (ii) the composition of each component in the vapour, and (iii) the vapour pressure when only a few drops of liquid remain. assume that the rate of vaporization is low enough for the temperature to remain constant at 20 °c.

Answers: 1

Answer

Chemistry, 22.06.2019 20:00

Phosphoric acid is a triprotic acid ( =6.9×10−3 , =6.2×10−8 , and =4.8×10−13 ). to find the ph of a buffer composed of h2po−4(aq) and hpo2−4(aq) , which p value should be used in the henderson–hasselbalch equation? p k a1 = 2.16 p k a2 = 7.21 p k a3 = 12.32 calculate the ph of a buffer solution obtained by dissolving 18.0 18.0 g of kh2po4(s) kh 2 po 4 ( s ) and 33.0 33.0 g of na2hpo4(s) na 2 hpo 4 ( s ) in water and then diluting to 1.00 l.

Answers: 3

Answer

You know the right answer?

3. To what Celsius temperature does 750. mL of gas originally at −12°C need to be heated to bring th...

Questions