Chemistry, 09.08.2021 20:50 kakalli9999

14C-Labeled glyceraldehyde 3-phosphate was added to a yeast extract. After a short time, fructose 1,6-bisphosphate labeled with 14C at C-3 and C-4 was isolated. What was the location of the 14C label in the starting glyceraldehyde 3-phosphate

Answers: 2

Show answers

Answers

Answer from: Quest

hey there!

boiling point is the temperature at which the vapor pressure of the liquid equals atmospheric pressure. the vapor pressure of solvent molecules is decreased when a solute is added, so a higher temperature is required to increase the number of solvent molecules in the gas phase above the liquid.

at the freezing point, the vapor pressures of the solid and liquid are equal; a lower temperature is needed to reduce the number of solvent particles above the liquid.

hope this you

tobey

Answer from: Quest

my dad did alot of meth and ace cheeks

Answer from: Quest

assuming that your periodic table has eighteen columns, you should highlight the four elements in the third column from the left of the table.

explanation

neutral atoms of elements after calcium contain d electrons. the energy of d orbitals of a particular main shell lies between the energy of the s and p orbitals of the next main shell. for example, electrons in the $3d$ have energy higher than those in the $4 s$ orbital while lower than those of the $4 p$ orbital.

by the aufbau principle, electrons fill orbitals one at a time, starting from those of the lowest energy. the $4s$ orbital is therefore filled right after $3p$ orbitals and before $3 d$ orbitals.

potassium has electron configuration $[\text{ar}] 4 s^{1}$ and calcium $[\text{ar}] 4 s^{2}$ . the s orbital of a main shell holds a maximum of two electrons. the next element would thus have the electron configuration $[\text{ar}] 4 s^{2} \; 3d^{1}$ and satisfy the requirements.

a neutral atom of the element contains three electrons on top of the most recent noble gas element. it should thus be placed in the third column of the periodic table. both scandium and yttrium would satisfy the conditions. an aufbau diagram indicates that the 4f orbital is filled before the 5d. however, it appears that exceptions exists for both lanthanum and actinium. neutral atoms of the two d-block elements also demonstrate the $ns^{2} \; (n-1) p^{1}$ and should be highlighted as well.

Answer from: Quest

Ions gain or lose electrons

Another question on Chemistry

Chemistry, 21.06.2019 23:30

Agroup of students is studying convection currents. they fill two identical balloons with the same amount of helium. one balloon is placed in a freezer and the other in an area with warm air. after 10 minutes, the balloons are released from a height of 1 meter. which of the following do the students most likely observe? a. the balloons both rise. the cold balloon is larger than the warm balloon. b. the balloons rise at the same rate. both balloons are the same size. c. the warm balloon expands and rises. the cold balloon shrinks and sinks. d. the cold balloon expands and rises. the warm balloon shrinks and sinks.

Answers: 2

Answer

Chemistry, 22.06.2019 18:00

How does climate change cause the ocean's thermohaline current to slow down?

Answers: 3

Answer

Chemistry, 22.06.2019 21:30

The solid xy decomposes into gaseous x and y: xy(s) m x(g) + y(g) kp = 4.1 (at 0 °c) if the reaction is carried out in a 22.4 l container, which initial amounts of x and y will result in the formation of solid xy?

Answers: 1

Answer

Chemistry, 22.06.2019 21:30

Liquid ammonia is produced at high temperatures and under great pressure in a tank by passing a mixture of nitrogen gas and hydrogen gas over an iron catalyst. the reaction is represented by the following equation. n2(g) + 3h2(g) → 2nh3(g) changing all but one experimental condition will affect the amount of ammonia produced. that condition is a) increasing the concentration of both reactants b) changing the temperature within the tank c) decreasing the pressure within the tank. d) increasing only the amount of nitrogen present.

Answers: 1

Answer

You know the right answer?

14C-Labeled glyceraldehyde 3-phosphate was added to a yeast extract. After a short time, fructose 1,...

Questions