Chemistry, 05.03.2022 02:00 trevorhenyan51

Use the rydberg equation to calculate the wavelength of a photon produced from the electron transition from n=2 to n=1 in a hydrogen atom.

Answers: 3

Show answers

Answers

Answer from: Quest

answer; i do believe the correct answer is (river); /// good luck

Answer from: Quest

assuming that your periodic table has eighteen columns, you should highlight the four elements in the third column from the left of the table.

explanation

neutral atoms of elements after calcium contain d electrons. the energy of d orbitals of a particular main shell lies between the energy of the s and p orbitals of the next main shell. for example, electrons in the $3d$ have energy higher than those in the $4 s$ orbital while lower than those of the $4 p$ orbital.

by the aufbau principle, electrons fill orbitals one at a time, starting from those of the lowest energy. the $4s$ orbital is therefore filled right after $3p$ orbitals and before $3 d$ orbitals.

potassium has electron configuration $[\text{ar}] 4 s^{1}$ and calcium $[\text{ar}] 4 s^{2}$ . the s orbital of a main shell holds a maximum of two electrons. the next element would thus have the electron configuration $[\text{ar}] 4 s^{2} \; 3d^{1}$ and satisfy the requirements.

a neutral atom of the element contains three electrons on top of the most recent noble gas element. it should thus be placed in the third column of the periodic table. both scandium and yttrium would satisfy the conditions. an aufbau diagram indicates that the 4f orbital is filled before the 5d. however, it appears that exceptions exists for both lanthanum and actinium. neutral atoms of the two d-block elements also demonstrate the $ns^{2} \; (n-1) p^{1}$ and should be highlighted as well.

Answer from: Quest

definition

entropy is a measure of the randomness or the extent of disorder of a chemical process.

enthalpy is a measure of the heat change of a reaction occurring at a constant pressure.

measurement units:

entropy is measured in joule per kelvin (jk⁻¹) whereas enthalpy is measured in joule per mole (jmol⁻¹)

requirements:

entropy has no requirements or limits, and its change is measured by the division between the heat change of the chemical process and the temperature.

in contrast, enthalpy can only be related to the heat change of the reaction under standard conditions.

Answer from: Quest

Carbon based or cells?

Another question on Chemistry

Chemistry, 22.06.2019 14:30

How many molecules are in 6.0 moles of methane

Answers: 1

Answer

Chemistry, 22.06.2019 16:50

Assuming complete dissociation of the solute, how many grams of kno3 must be added to 275 ml of water to produce a solution that freezes at -14.5 c? the freezing point for pure water is 0.0 c and k_f is equal to 1.86 c/m

Answers: 3

Answer

Chemistry, 22.06.2019 23:30

Why do oxygen have a strong attractive force for electrons

Answers: 2

Answer

Chemistry, 23.06.2019 05:30

The image compares the arrangement of electrons in two different neutral atoms. a figure labeled atom q has a shaded sphere at the center of three concentric circles. the innermost circle has two black spheres. the middle circle has six black spheres. to the left of this figure is another figure labeled atom p. atom p has a shaded sphere at the center of three concentric circles. the innermost circle has two black spheres. the middle circle has seven black spheres. which of the following best explains the position of the two atoms in the periodic table? atom p has an estimated zeff of 7 and is therefore to the left of atom q, which has a zeff of 6. atom p has an estimated zeff of 7 and is therefore to the right of atom q, which has a zeff of 6. atom p has an estimated zeff of 5 and is therefore below atom q, which has a zeff of 4. atom p has an estimated zeff of 5 and is therefore above atom q, which has a zeff of 4.

Answers: 3

Answer

You know the right answer?

Use the rydberg equation to calculate the wavelength of a photon produced from the electron transiti...

Questions