Write a program proj3_1.cpp that reads from user the length in feet and inches into two separate variables. then, your program should convert the feet and inches into two other variables holding meters and centimeters. must use only the conversion factor between feet and meters of 0.3048 meter/feet along with 12 inches in a foot and 100 centimeters in a meter. you should use 3 functions: one for input, one for conversion, and one for displaying the results with the following prototypes: void getfeetinches(int & feet, int & inches); void coverttometercentimeter(int feet, int inches, int & meters, int & centimeters); void displayresults(int feet, int inches, int meters, int centimeters);

Sometimes writers elaborate on the truth when recalling past events so they can enhance their narrative essay with more interesting descriptions. do you feel that published writers should or should not embellish real life events just to make their stories more interesting?

Assume that there is a 4% rate of disk drive failure in a year. a. if all your computer data is stored on a hard disk drive with a copy stored on a second hard disk drive, what is the probability that during a year, you can avoid catastrophe with at least one working drive? b. if copies of all your computer data are stored on three independent hard disk drives, what is the probability that during a year, you can avoid catastrophe with at least one working drive?

Write a program in plp assembly that counts up by one starting from zero (or one) inside a loop and writes this value to the leds every time the value is increased. the memory address of the leds is 0xf0200000. the table below shows the meaning and an example usage of the instructions covered in the video, plp instructions for project 1. instruction example usage meaning load immediate li $t0, 8 register $t0 is set to the value, 8. store word sw $t2, 0($t1) the value in register $t1 is used as the memory address. the value in register $t2 is copied into this memory address. add addiu $t4, $t3, 29 register $t4 is assigned the sum of 29 and the value in register $t3. jump j your_label_name the program jumps to the line following the label, "your_label_name: ". label your label name: defines a label called "your_label_name: " that can be jumped to