You have recently installed a new switch and in the future you would like to manage the switch from a remote location. to remotely manage the switch, you need to complete the following configuration tasks: ·

1. configure the vlan 1 interface with the following ip address: 192.168.11.250with a mask of 255.255.255.0. ·
2. configure the switch to use 192.168.11.254as the default gateway. ·
3. save your changes to the startup-config file.

Consider a slotted aloha system, where the time slot equals the fixed duration of each packet. assume that there are 4 stations a,b,c,d sharing the medium. (a) stations a,b,c,d receive one packet each from higher layers at times 1.3, 1.5, 2.6,5.7 respectively. show which transmissions take place when, according to the slottedaloha protocol; describe all transmissions until all four packets have been successful.when needed, each station has access to the following sequence of random number, provided by a random number generator and drawn uniformly between 0 and 1: (1) station a draws numbers: 0.31, 0.27, 0.78, 0.9, 0.9, 0.11, 0. (2) station b draws numbers: 0.45, 0.28, 0.11, 0.83, 0.37, 0.22, 0. (3)station c draws numbers: 0.1, 0.2, 0.3, 0.4, 0. (4) station d draws numbers: 0.36, 0.77, 0.9, 0.1, 0.1, 0.1, 0.1, 0. (b) in slotted aloha, a station transmits in each time slot with a given probability. what probabilities would you assign to each of the four stations so as to: (i) maximize the efficiency of the protocol? (ii) maximize fairness among the four stations? (c) will the efficiency increase or decrease if we modify slotted aloha as follows: (i) get rid of slots and allow stations to transmit immediately? (ii) implement carrier sensing? (iii) implement collision detection? (iv) implement collision avoidance?

Write a program that reads a set of floating-point values. ask the user to enter the values, then print • the average of the values. • the smallest of the values. • the largest of the values. • the range, that is the difference between the smallest and largest. of course, you may only prompt for the values once.

Acontact list is a place where you can store a specific contact with other associated information such as a phone number, email address, birthday, etc. write a program that first takes in word pairs that consist of a name and a phone number (both strings). that list is followed by a name, and your program should output that name's phone number.