Computers and Technology, 03.01.2020 03:31 greend0719

Given an int variable datum that has already been declared, write a few statements that read an integer value from standard input into this variable.

Answers: 2

Show answers

Another question on Computers and Technology

Computers and Technology, 23.06.2019 09:30

Given a link with a maximum transmission rate of 32.8 mbps. only two computers, x and y, wish to transmit starting at time t = 0 seconds. computer x sends filex (4 mib) and computer y sends filey (244 kib), both starting at time t = 0. statistical multiplexing is used, with details as follows packet payload size = 1000 bytes packet header size = 24 bytes (overhead) ignore processing and queueing delays assume partial packets (packets consisting of less than 1000 bytes of data) are padded so that they are the same size as full packets. assume continuous alternating-packet transmission. computer x gets the transmission medium first. at what time (t = ? ) would filey finish transmitting? give answer in milliseconds, without units, and round to one decimal places (e.g. for an answer of 0.013777 seconds you would enter "13.8" without the quotes)

Answers: 3

Answer

Computers and Technology, 23.06.2019 12:40

Curriculum exam to process a resident's payment, you must click on onesite payments home page. from the a. reports b. my settings o c.transactions o d. rent tab

Answers: 1

Answer

Computers and Technology, 23.06.2019 17:30

What are the most commonly found items in the trash according to the municipal solid waste report?

Answers: 1

Answer

Computers and Technology, 24.06.2019 10:20

Write a program that keeps asking the user for new values to be added to a list until the user enters 'exit' ('exit' should not be added to the list). these values entered by the user are added to a list we call 'initial_list'. then write a function that takes this initial_list as input and returns another list with 3 copies of every value in the initial_list. finally, inside print out all of the values in the new list. for example: input: enter value to be added to list: a enter value to be added to list: b enter value to be added to list: c enter value to be added to list: exit output: a b c a b c a b c note how 'exit' is not added to the list. also, your program needs to be able to handle any variation of 'exit' such as 'exit', 'exit' etc. and treat them all as 'exit'.

Answers: 2

Answer

You know the right answer?

Given an int variable datum that has already been declared, write a few statements that read an inte...

Questions