subject

You need to find out more about the fdisk utility and the commands associated with it before you set up a new Linux system in addition to the one you are already using. What command can you use on your present system to find out more about fdisk?

a. man fdisk
b. fdisk /?
c. fdisk /help
d. find fdisk

ansver
Answers: 1

Another question on Computers and Technology

question
Computers and Technology, 22.06.2019 06:30
This technology is used to produce high-quality documents that look good on the computer screen and in print.
Answers: 1
question
Computers and Technology, 22.06.2019 16:50
Consider a slotted aloha system, where the time slot equals the fixed duration of each packet. assume that there are 4 stations a,b,c,d sharing the medium. (a) stations a,b,c,d receive one packet each from higher layers at times 1.3, 1.5, 2.6,5.7 respectively. show which transmissions take place when, according to the slottedaloha protocol; describe all transmissions until all four packets have been successful.when needed, each station has access to the following sequence of random number, provided by a random number generator and drawn uniformly between 0 and 1: (1) station a draws numbers: 0.31, 0.27, 0.78, 0.9, 0.9, 0.11, 0. (2) station b draws numbers: 0.45, 0.28, 0.11, 0.83, 0.37, 0.22, 0. (3)station c draws numbers: 0.1, 0.2, 0.3, 0.4, 0. (4) station d draws numbers: 0.36, 0.77, 0.9, 0.1, 0.1, 0.1, 0.1, 0. (b) in slotted aloha, a station transmits in each time slot with a given probability. what probabilities would you assign to each of the four stations so as to: (i) maximize the efficiency of the protocol? (ii) maximize fairness among the four stations? (c) will the efficiency increase or decrease if we modify slotted aloha as follows: (i) get rid of slots and allow stations to transmit immediately? (ii) implement carrier sensing? (iii) implement collision detection? (iv) implement collision avoidance?
Answers: 3
question
Computers and Technology, 22.06.2019 20:00
What side length would you specify if you were required to create a regular hexagonal plate that was composed of 33 cm(squared) of sheet metal? dimension the side length to 0.1 cm
Answers: 2
question
Computers and Technology, 23.06.2019 15:30
Write a program in plp assembly that counts up by one starting from zero (or one) inside a loop and writes this value to the leds every time the value is increased. the memory address of the leds is 0xf0200000. the table below shows the meaning and an example usage of the instructions covered in the video, plp instructions for project 1. instruction example usage meaning load immediate li $t0, 8 register $t0 is set to the value, 8. store word sw $t2, 0($t1) the value in register $t1 is used as the memory address. the value in register $t2 is copied into this memory address. add addiu $t4, $t3, 29 register $t4 is assigned the sum of 29 and the value in register $t3. jump j your_label_name the program jumps to the line following the label, "your_label_name: ". label your label name: defines a label called "your_label_name: " that can be jumped to
Answers: 2
You know the right answer?
You need to find out more about the fdisk utility and the commands associated with it before you set...
Questions
question
Mathematics, 10.10.2019 04:00
Questions on the website: 13722361