The router commands used to configure and enable the FastEthernet 0/1 router interface with the IP address of 10.10.20.250 and a subnet mask of 255.255.0.0 are: Router# conf t Router(config)# int fa0/1 Router(config-if)# ip address 10.10.20.250 255.255.0.0 Router(config-if)# no shut

A. True
B. False

Check my work the microprocessor is a(n) circuit, which is designed to process data based on a set of instructions. most desktop and laptop devices contain a microprocessor based on the standard. most tablets and smartphones contain processors based on technology. a microprocessor's circuitry is designed to perform a limited number of tasks contained in its set. during processing, an instruction is loaded into the processor's unit. data is loaded into registers in the processor's where arithmetic and logic operations are performed. microprocessor performance can be measured by its speed. other factors affecting overall processing performance include word size, cache size, and instruction set complexity. most digital devices contain only one microprocessor chip, but today's multi- processors contain circuitry that supports parallel processing. computers contain various kinds of memory. random memory is a special holding area for data, program instructions, and the system. it stores data on a temporary basis until the processor makes a data request. ram is different from disk storage because it is , which means that it can hold data only when the computer power is turned on. computers also contain read- memory, which is a type of non-volatile memory that provides a set of "hard-wired" instructions, called the loader, that a computer uses to boot up.

1. ask the user how many questions are in the quiz. 2. ask the user to enter the key (that is, the correct answers). there should be one answer for each question in the quiz, and each answer should be an integer. e.g., 34 7 13 100 81 3 9 10 321 12 might be the key for a 10-question quiz. you will need to store the key in an array. 3. ask the user to enter the answers for the quiz to be graded. there needs to be one answer for each question. note that these answers do not need to be stored; each answer can simply be compared to the key as it is entered. 4. when the user has entered all of the answers to be graded, print the number correct and the percent correct. 5. add a loop so that the user can grade any number of quizzes with a single key. after the results have been printed for each quiz, ask "grade another quiz? (y/n)." note: you only have one array (the key). you are not creating a new key for each set of quiz answers.

Write pseudocode to represent the logic of a program that allows the user to enter a value. the program multiplies the value by 10 and outputs the result.