Additional 11-08 Construct a Turing machine in JFLAP that takes strings over the alphabet {0,1} and adds 1 to a Binary number. Start with a binary number on the tape, and halt with your tape head pointing to the first digit in the new number (Yes, this is the problem from the video, and yes, I give it to you, but you should do it from scratch to convince yourself you can do it!)

Which law requires employers to provide safe working environments for their employees? a. civil rights act b. fair labor standards act c. occupational safety and health act d. wagner act

In a response of approximately 50 words, explain why it would be essential for the successful a/v technician to participate in additional coursework, presentations and seminars offered by equipment manufacturers as well as annual conferences attended by colleagues in the industry.

Write a program that displays the following menu: geometry calculator 1. calculate the area of a circle 2. calculate the area of a rectangle 3. calculate the area of a triangle 4. quit enter your choice (1-4): if the user enters 1, the program should ask for the radius of the circle and then display its area. use the following formula: area = ď€(the square of r) use 3.14159 for ď€ and the radius of the circle for r. if the user enters 2, the program should ask for the length and width of the rectangle and then display the rectangle’s area. use the following formula: area = length * width if the user enters 3, the program should ask for the length of the triangle’s base and its height, and then display its area. use the following formula: area = base * height * .5 if the user enters 4, the program should end. input validation: display an error message if the user enters a number outside the range of 1 through 4 when selecting an item from the menu. do not accept negative values for the circle’s radius, the rectangle’s length or width, or the triangle’s base or height. note: if the user enters an improper menu choice (1-4), the program prints "the valid choices are 1 through 4. run the program again and select one of those." if the user enters a negative radius, the program prints "the radius can not be less than zero." if the user enters a negative value for height or base, the program prints "only enter positive values for base and height."