Write a MIPS Assembly Language program that computes the area and the perimeter of a rectangle given the width and the height. The width and height are read from the standard input after prompting the user, and then the program computes the area and the perimeter then prints it on the standard output.

Which part of the cpu accepts data?

Write a program that displays the following menu: geometry calculator 1. calculate the area of a circle 2. calculate the area of a rectangle 3. calculate the area of a triangle 4. quit enter your choice (1-4): if the user enters 1, the program should ask for the radius of the circle and then display its area. use the following formula: area = ď€(the square of r) use 3.14159 for ď€ and the radius of the circle for r. if the user enters 2, the program should ask for the length and width of the rectangle and then display the rectangle’s area. use the following formula: area = length * width if the user enters 3, the program should ask for the length of the triangle’s base and its height, and then display its area. use the following formula: area = base * height * .5 if the user enters 4, the program should end. input validation: display an error message if the user enters a number outside the range of 1 through 4 when selecting an item from the menu. do not accept negative values for the circle’s radius, the rectangle’s length or width, or the triangle’s base or height. note: if the user enters an improper menu choice (1-4), the program prints "the valid choices are 1 through 4. run the program again and select one of those." if the user enters a negative radius, the program prints "the radius can not be less than zero." if the user enters a negative value for height or base, the program prints "only enter positive values for base and height."

Write a new lc-3 trap subroutine (i.e. a subroutine that will be invoked via the trap instruction) that will receive a numeric digit entered at the keyboard (i.e. an ascii character), echo it to the screen, and return in r0 the corresponding numeric value: so if the user types the digit '7', the character '7' will appear on the screen, but the value returned in r0 will be b0000 0000 0000 0111 (#7) you may not use any trap calls in your code - you must implement the "polling" code that interrogates the keyboard status and data registers. ; getnum_tsr ; a subroutine for obtaining a numeric value ; given ascii numeric digit input to keyboard. ; the numeric digit is echoed to the console (e.g. '7' = b0000 0000 0011 0111), ; but the value returned in r0 is the actual numeric value ; corresponding to the digit (e.g. b0000 0000 0000 0111 =