Research and a well-written problem statement are important because

ANSWER: A) they give a clear understanding of the problem and its solution

What side length would you specify if you were required to create a regular hexagonal plate that was composed of 33 cm(squared) of sheet metal? dimension the side length to 0.1 cm

Select the correct answer. andre was recently hired by an organization to check for system vulnerabilities. he is supposed to exploit these vulnerabilities and create a report on the extent of damage to which the system was susceptible. what position does andre hold in this organization? a. information security analyst b. information assurance manager c. penetration tester d. network security engineer e. chief information security officer

Write a program that displays the following menu: geometry calculator 1. calculate the area of a circle 2. calculate the area of a rectangle 3. calculate the area of a triangle 4. quit enter your choice (1-4): if the user enters 1, the program should ask for the radius of the circle and then display its area. use the following formula: area = ď€(the square of r) use 3.14159 for ď€ and the radius of the circle for r. if the user enters 2, the program should ask for the length and width of the rectangle and then display the rectangle’s area. use the following formula: area = length * width if the user enters 3, the program should ask for the length of the triangle’s base and its height, and then display its area. use the following formula: area = base * height * .5 if the user enters 4, the program should end. input validation: display an error message if the user enters a number outside the range of 1 through 4 when selecting an item from the menu. do not accept negative values for the circle’s radius, the rectangle’s length or width, or the triangle’s base or height. note: if the user enters an improper menu choice (1-4), the program prints "the valid choices are 1 through 4. run the program again and select one of those." if the user enters a negative radius, the program prints "the radius can not be less than zero." if the user enters a negative value for height or base, the program prints "only enter positive values for base and height."