Canadian Tire is one of Canada’s largest companies. They operate four large distribution centers service over 470 tire retail outlets. They recently installed a Yard Management System (YMS), which they have integrated with their Warehouse Management Systems (WMS) and Transport Management System (TMS) systems. Their expectation was improved performance in over-the-road transportation equipment utilization, driver productivity, and warehouse dock/door utilization. As a relatively new logistics employee, you have been asked to develop an evaluation system to measure operational productivity improvement. While management does not want a financial impact evaluation, they are interested in developing benchmarks to measure initial and sustainable productivity improvement. You have the job-how would you proceed?

What’s resistance in an electrical circuit ?

Write a computer program to calculate the three-phase fault current for a fault at f in figure 1.16, with the network normal, and with one line at a time removedproblems 1.1 write a computer program to calculate the three-phase fault current for a fault at f in figure 1.16, with the network normal, and with one line at a time removed 20 power system relaying from service. the positive-sequence impedance data are given in the accompanying table. use the commonly made assumption that all prefault resistance values are (1.0+j0.0) pu, and neglect all resistance values. calculate the contribution to the fault flowing through the cb b and the voltage at that bus. for each calculated case, consider the two possibilities: cb b2 closed or open. the latter is known as the stub-end fault í• figure 1.16 problem 1.1 system data for figure 1.16 from to positive sequence 0.0+j0.1 0.05j0.15 0.04 j0.2 0.01 jo.i 0.015 + j0.15 0.01 j0.19 0.01 +j0.19 0.03+j0.1 0.0+j0.08 6 6 6 from service. the positive-sequence impedance data are given in the accompanying table. use the commonly made assumption that all prefault resistance values are (1.0 + j 0.0) pu, and neglect all resistance values. calculate the contribution to the fault flowing through the cb b1, and the voltage at that bus. for each calculated case, consider the two possibilities: cb b2 closed or open. the latter is known as the “stub-end” fault.

1. technician a says horsepower information can be used by consumers to compare the power of different automobile engines. technician b says that manufacturers will often list the horsepower output of their engines in the online service information. who is right?