Computers and Technology, 12.03.2021 15:40 kvngnick
Stopwatch with Halt/Resume and Reset Functions When the button S1 is pushed, the counting should stop and the current number should remain on the display. Pushing S1 again should resume the counting from the currently displayed value. Pushing S2 should reset the count to zero. If the reset is performed during counting, the value should go to zero and the counting should continue. If the reset is performed when the counting is halted, the value should go to zero and the stopwatch should remain halted. Indicate the counting/halted status using the LED lights. When the stopwatch is counting, the green LED should be on. When the stopwatch is halted, the red LED should be on.
Answers: 3
Another question on Computers and Technology
Computers and Technology, 23.06.2019 17:30
Scientists have changed the model of the atom as they have gathered new evidence. one of the atomic models is shown below. what experimental evidence led to the development of this atomic model from the one before it? a few of the positive particles aimed at a gold foil seemed to bounce back. the colors of light emitted from heated atoms had very specific energies. experiments with water vapor showed that elements combine in specific proportions. cathode rays were bent in the same way whenever a magnet was brought near them.
Answers: 2
Computers and Technology, 23.06.2019 18:00
Which is a possible benefit of having a good credit history? having a checking account low interest rate on a car loan high interest rate on a credit card offer bankruptcy
Answers: 1
Computers and Technology, 23.06.2019 19:40
Use a physical stopwatch to record the length of time it takes to run the program. calculate the difference obtained by calls to the method system.currenttimemillis() just before the start of the algorithm and just after the end of the algorithm. calculate the difference obtained by calls to the method system.currenttimemillis() at the start of the program and at the end of the program so that the elapsed time includes the display of the result. use the value returned by the method system.currenttimemillis() just after the end of the algorithm as the elapsed time.
Answers: 3
You know the right answer?
Stopwatch with Halt/Resume and Reset Functions When the button S1 is pushed, the counting should sto...
Questions
Geography, 28.10.2019 13:31
Mathematics, 28.10.2019 13:31
Mathematics, 28.10.2019 13:31
Social Studies, 28.10.2019 13:31
Mathematics, 28.10.2019 13:31
Computers and Technology, 28.10.2019 13:31
