subject

Assignment #9 will be the construction of a program that reads in a sequence of integers from standard input until 0 is read, and stores them in an array (zero is the sentinel-it is not stored in the array). This is done using iteration (choose while or do-while loop). You may assume that there will not be more than 100 numbers. Then find the maximum number, find the largest even integer, sum of the numbers that are larger than the last number in the array, and count of numbers that are divisible by 3 using recursion. Thus, you will create four recursive methods findMax, largestEven, sumLargerThanLast and countDivisibleBy3 in Assignment9 class and they will be called by the main method. Specifically, the following recursive methods must be implemented (These methods should not contain any loop): public static int findMax(int[] numbers, int startIndex, int endIndex) public static int largestEven(int[] numbers, int startIndex, int endIndex) public static int sumLargerThanLast(int[] numbers, int startIndex, int endIndex, int lastElement) public static int countDivisibleBy3(int[] numbers, int startIndex, int endIndex)

ansver
Answers: 3

Another question on Computers and Technology

question
Computers and Technology, 23.06.2019 15:30
Write a program in plp assembly that counts up by one starting from zero (or one) inside a loop and writes this value to the leds every time the value is increased. the memory address of the leds is 0xf0200000. the table below shows the meaning and an example usage of the instructions covered in the video, plp instructions for project 1. instruction example usage meaning load immediate li $t0, 8 register $t0 is set to the value, 8. store word sw $t2, 0($t1) the value in register $t1 is used as the memory address. the value in register $t2 is copied into this memory address. add addiu $t4, $t3, 29 register $t4 is assigned the sum of 29 and the value in register $t3. jump j your_label_name the program jumps to the line following the label, "your_label_name: ". label your label name: defines a label called "your_label_name: " that can be jumped to
Answers: 2
question
Computers and Technology, 24.06.2019 00:10
Read each statement below. if the statement describes a peer-to-peer network, put a p next to it. if the statement describes a server-based network, put an s next to it. p - peer-to-peer s - server-based
Answers: 1
question
Computers and Technology, 24.06.2019 21:00
When replacing a thermostat or water pump, coolant drained from the cooling system should be
Answers: 1
question
Computers and Technology, 24.06.2019 22:30
Distinguish between a skill resume and a chronological resume and explain when it is best to use each format
Answers: 1
You know the right answer?
Assignment #9 will be the construction of a program that reads in a sequence of integers from standa...
Questions
question
Mathematics, 25.08.2021 04:10
question
Computers and Technology, 25.08.2021 04:10
Questions on the website: 13722363