Are commonly used to control the number of times that a loop iterates?

Hmm... I feel like this query is much broader than it should be. However, I will start my initial answer, then another potential solution.

My initial answer to your query was: A condition controlled loop is used to control the number of times a loop iterates.

The potential answer, my secondary one, is: A count controlled loop iterates a specific number of times.

Two results, but my initial answer is the solution I opted when understanding this.

Wow the answer was a on e dgenuity, ignore the other autistic answers 

Through the process of sedimentation,sediment is turned back to rock to form sedimentation.the process of sedimentation is: > deposition-where fragments were deposited into the river or sea under gravity or travelling agent such as wind or water. > sedimentation-the fragments deposited in the river sedimented and accumulate> compaction-the layers of fragments deposited undergoes compaction due to the weight if the upper layers> cementation-chemical substance of the fragments such as cement dissolved into the water and cement the other fragments together to form sedimentary rock.thus,cementation and compaction are the process.on the other hand, transformation only occur when a rock under goes metamorphism(compaction or extreme heat).while recrystillization occurs when a rock is melted and cooled down,which also requires metamorphism to take place.hope it !